اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدTheoretical aspect of enhancement and saturation in emission from laser produced plasma
90
0
0.0
(
0
)
تأليف
V. N. Rai
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
This paper presents a simplified theoretical model for the study of emission from laser produced plasma to better understand the processes and the factors involved in the onset of saturation in plasma emission as well as in increasing emission due to plasma confinement. This model considers that plasma emission is directly proportional to the square of plasma density, its volume and the fraction of laser pulse absorbed through inverse Bremsstrahlung in the pre-formed plasma plume produced by the initial part of the laser. This shows that plasma density and temperature decide the threshold for saturation in emission, which occurs for electron ion collision frequency more than 10E13 Hz, beyond which plasma shielding effects become dominant. Any decrease in plasma sound (expansion) velocity shows drastic enhancement in emission supporting the results obtained by magnetic as well as spatial confinement of laser produced plasma. The temporal evolution of plasma emission in the absence and presence of plasma confinement along with the effect of laser pulse duration are also discussed in the light of this model.
قيم البحث
اقرأ أيضاً
The hard x-ray emission in the energy range of 30-300 keV from copper plasmas produced by 100 fs, 806 nm laser pulses at intensities in the range of 10$^{15}-10^{16}$ W cm$^{-2}$ is investigated. We demonstrate that surface roughness of the targets o
verrides the role of polarization state in the coupling of light to the plasma. We further show that surface roughness has a significant role in enhancing the x-ray emission in the above mentioned energy range.
Time-resolved optical emission spectroscopic measurements of a plasma generated by irradiating a Cr target using 60 picosecond (ps) and 300 ps laser pulses is carried out to investigate the variation in the linewidth ($deltalambda$) of emission from
neutrals and ions for increasing ambient pressures. Measurements ranging from 10$^{-6}$ Torr to 10$^2$ Torr show a distinctly different variation in the $deltalambda$ of neutrals (Cr I) compared to that of singly ionized Cr (Cr II), for both irradiations. $deltalambda$ increases monotonously with pressure for Cr II, but an oscillation is evident at intermediate pressures for Cr I. This oscillation does not depend on the laser pulse widths used. In spite of the differences in the plasma formation mechanisms, it is experimentally found that there is an optimum intermediate background pressure for which $deltalambda$ of neutrals drops to a minimum. Importantly, these results underline the fact that for intermediate pressures, the usual practice of calculating the plasma number density from the $deltalambda$ of neutrals needs to be judiciously done, to avoid reaching inaccurate conclusions.
Recent experiments have observed magnetic reconnection in high-energy-density, laser-produced plasma bubbles, with reconnection rates observed to be much higher than can be explained by classical theory. Based on fully kinetic particle simulations we
find that fast reconnection in these strongly driven systems can be explained by magnetic flux pile-up at the shoulder of the current sheet and subsequent fast reconnection via two-fluid, collisionless mechanisms. In the strong drive regime with two-fluid effects, we find that the ultimate reconnection time is insensitive to the nominal system Alfven time.
The plasma density grating induced by intersecting intense laser pulses can be utilized as an optical compressors, polarizers, waveplates and photonic crystals for the manipulation of ultra-high-power laser pulses. However, the formation and evolutio
n of the plasma density grating are still not fully understood as linear models are adopted to describe them usually. In this paper, two nonlinear theoretical models are presented to study the formation process of the plasma density grating. In the first model, a nonlinear analytical solution based on the fluid equations is presented while in the second model a particle-mesh method is adopted to investigate the kinetic effects. It is found that both models can describe the plasma density grating formation at different stages, well beyond the linear growth stage. More importantly, the second model can reproduce the phenomenon of ion wave-breaking of plasma density grating, which eventually induces the saturation of plasma density grating. Using the second model, the saturation time of the plasma density grating is obtained as a function of laser intensity and plasma density, which can be applied to estimate the lifetime of the plasma density grating in experiments. The results from these two nonlinear models are verified using particle-in-cell simulations.
We present an in-depth experimental-computational study of the parameters necessary to optimize a tunable, quasi-monoenergetic, efficient, low-background Compton backscattering (CBS) x-ray source that is based on the self-aligned combination of a las
er-plasma accelerator (LPA) and a plasma mirror (PM). The main findings are: (1) an LPA driven in the blowout regime by 30 TW, 30 fs laser pulses producesnot only a high-quality, tunable, quasi-monoenergetic electron beam, but also a high-quality, relativistically intense (a0~1) spent drive pulse that remains stable in profile and intensity over the LPA tuning range. (2) A thin plastic film near the gas jet exit retro-reflects the spent drive pulse efficiently into oncoming electrons to produce CBS x-rays without detectable bremsstrahlung background. Meanwhile anomalous far-field divergence of the retro-reflected light demonstrates relativistic denting of the PM. Exploiting these optimized LPA and PM conditions, we demonstrate quasi-monoenergetic (50% FWHM energy spread), tunable (75 to 200 KeV) CBS x-rays, characteristics previously achieved only on more powerful laser systems by CBS of a split-off, counter-propagating pulse. Moreover, laser-to-x-ray photon conversion efficiency ~6e12 exceeds that of any previous LPA-based quasi-monoenergetic Compton source. Particle-in-cell simulations agree well with the measurements.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
