اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدHigh-field charge transport on the surface of Bi$_2$Se$_3$
196
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We present a theoretical study on the high-field charge transport on the surface of Bi$_2$Se$_3$ and reproduce all the main features of the recent experimental results, i.e., the incomplete current saturation and the finite residual conductance in the high applied field regime [Costache {it et al.}, Phys. Rev. Lett. {bf 112}, 086601 (2014)]. Due to the hot-electron effect, the conductance decreases and the current shows the tendency of the saturation with the increase of the applied electric field. Moreover, the electric field can excite carriers within the surface bands through interband precession and leads to a higher conductance. As a joint effect of the hot-electron transport and the carrier excitation, the conductance approaches a finite residual value in the high-field regime and the current saturation becomes incomplete. We thus demonstrate that, contrary to the conjecture in the literature, the observed transport phenomena can be understood qualitatively in the framework of surface transport alone. Furthermore, if a constant bulk conductance which is insensitive to the field is introduced, one can obtain a good quantitative agreement between the theoretical results and the experimental data.
قيم البحث
اقرأ أيضاً
The influence of individual impurities of Fe on the electronic properties of topological insulator Bi$_2$Se$_3$ is studied by Scanning Tunneling Microscopy. The microscope tip is used in order to remotely charge/discharge Fe impurities. The charging
process is shown to depend on the impurity location in the crystallographic unit cell, on the presence of other Fe impurities in the close vicinity, as well as on the overall doping level of the crystal. We present a qualitative explanation of the observed phenomena in terms of tip-induced local band bending. Our observations evidence that the specific impurity neighborhood and the position of the Fermi energy with respect to the Dirac point and bulk bands have both to be taken into account when considering the electron scattering on the disorder in topological insulators.
We perform ab-initio calculations on Bi$_mathrm{{Se}}$ antisite defects in the surface of Bi$_2$Se$_3$, finding strong low-energy defect resonances with a spontaneous ferromagnetism, fixed to an out-of-plane orientation due to an exceptional large ma
gnetic anisotropy energy. For antisite defects in the surface layer, we find semi-itinerant ferromagnetism and strong hybridization with the Dirac surface state, generating a finite energy gap. For deeper lying defects, such hybridization is largely absent, the magnetic moments becomes more localized, and no energy gap is present.
The band bending (BB) effect on the surface of the second-generation topological insulators implies a serious challenge to design transport devices. The BB is triggered by the effective electric field generated by charged impurities close to the surf
ace and by the inhomogeneous charge distribution of the occupied surface states. Our self-consistent calculations in the Korringa-Kohn-Rostoker framework showed that in contrast to the bulk bands, the spectrum of the surface states is not bent at the surface. In turn, it is possible to tune the energy level of the Dirac point via the deposited surface dopants. In addition, the electrostatic modifications induced by the charged impurities on the surface induce long range oscillations in the charge density. For dopants located beneath the surface, however, these oscillations become highly suppressed. Our findings are in good agreement with recent experiments, however, our results indicate that the concentration of the surface doping cannot be estimated from the energy shift of the Dirac cone within the scope of the effective continuous model for the protected surface states.
We study the fate of the surface states of Bi$_2$Se$_3$ under disorder with strength larger than the bulk gap, caused by neon sputtering and nonmagnetic adsorbates. We find that neon sputtering introduces strong but dilute defects, which can be model
ed by a unitary impurity distribution, whereas adsorbates, such as water vapor or carbon monoxide, are best described by Gaussian disorder. Remarkably, these two disorder types have a dramatically different effect on the surface states. Our soft x-ray ARPES measurements combined with numerical simulations show that unitary surface disorder pushes the Dirac state to inward quintuplet layers, burying it below an insulating surface layer. As a consequence, the surface spectral function becomes weaker, but retains its quasiparticle peak. This is in contrast to Gaussian disorder, which smears out the quasiparticle peak completely. At the surface of Bi$_2$Se$_3$, the effects of Gaussian disorder can be reduced by removing surface adsorbates using neon sputtering, which, however, introduces unitary scatterers. Since unitary disorder has a weaker effect than Gaussian disorder, the ARPES signal of the Dirac surface state becomes sharper upon sputtering.
The protected electron states at the boundaries or on the surfaces of topological insulators (TIs) have been the subject of intense theoretical and experimental investigations. Such states are enforced by very strong spin-orbit interaction in solids
composed of heavy elements. Here, we study the composite particles -- chiral excitons -- formed by the Coulomb attraction between electrons and holes residing on the surface of an archetypical three-dimensional topological insulator (TI), Bi$_2$Se$_3$. Photoluminescence (PL) emission arising due to recombination of excitons in conventional semiconductors is usually unpolarized because of scattering by phonons and other degrees of freedom during exciton thermalization. On the contrary, we observe almost perfectly polarization-preserving PL emission from chiral excitons. We demonstrate that the chiral excitons can be optically oriented with circularly polarized light in a broad range of excitation energies, even when the latter deviate from the (apparent) optical band gap by hundreds of meVs, and that the orientation remains preserved even at room temperature. Based on the dependences of the PL spectra on the energy and polarization of incident photons, we propose that chiral excitons are made from massive holes and massless (Dirac) electrons, both with chiral spin textures enforced by strong spin-orbit coupling. A theoretical model based on such proposal describes quantitatively the experimental observations. The optical orientation of composite particles, the chiral excitons, emerges as a general result of strong spin-orbit coupling in a 2D electron system. Our findings can potentially expand applications of TIs in photonics and optoelectronics.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
