اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدThe non-monotonic shear-thinning flow of two strongly cohesive concentrated suspensions
190
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The behaviour in simple shear of two concentrated and strongly cohesive mineral suspensions showing highly non-monotonic flow curves is described. Two rheometric test modes were employed, controlled stress and controlled shear-rate. In controlled stress mode the materials showed runaway flow above a yield stress, which, for one of the suspensions, varied substantially in value and seemingly at random from one run to the next, such that the up flow-curve appeared to be quite irreproducible. The down-curve was not though, as neither was the curve obtained in controlled rate mode, which turned out to be triple-valued in the region where runaway flow was seen in controlled rising stress. For this first suspension, the total stress could be decomposed into three parts to a good approximation: a viscous component proportional to a plastic viscosity, a constant isostatic contribution, and a third shear-rate dependent contribution associated with the particulate network which decreased with increasing shear-rate raised to the -7/10th power. In the case of the second suspension, the stress could be decomposed along similar lines, although the strain-rate softening of the solid-phase stress was found to be logarithmic and the irreducible isostatic stress was small. The flow curves are discussed in the light of recent simulations and they conform to a very simple but general rule for non-monotonic behaviour in cohesive suspensions and emulsions, namely that it is caused by strain-rate softening of the solid phase stress.
قيم البحث
اقرأ أيضاً
The discontinuous shear thickening (DST) of dense suspensions is a remarkable phenomenon in which the viscosity can increase by several orders of magnitude at a critical shear rate. It has the appearance of a first order phase transition between two
hypothetical states that we have recently identified as Stokes flows with lubricated or frictional contacts, respectively. Here we extend the analogy further by means of novel stress-controlled simulations and show the existence of a non-monotonic steady-state flow curve analogous to a non-monotonic equation of state. While we associate DST with an S-shaped flow curve, at volume fractions above the shear jamming transition the frictional state loses flowability and the flow curve reduces to an arch, permitting the system to flow only at small stresses. Whereas a thermodynamic transition leads to phase separation in the coexistence region, we observe a uniform shear flow all along the thickening transition. A stability analysis suggests that uniform shear may be mechanically stable for the small Reynolds numbers and system sizes in a rheometer.
The yielding of concentrated cohesive suspensions can be deformation-rate dependent. One consquence of this is that a single suspension can present in one several different ways, depending upon how it is tested, or more generally, how it is caused to
flow. We have seen variously Herschel-Bulkley flow, highly non-monotonic flow curves and highly erratic or chaotic yield, all in one suspension. In controlled-rate testing one sees a systematic effect of deformation rate. In controlled stress testing, matters are more subtle. Whereas step-stress creep testing will elicit reproducible behaviour, any attempt to determine a flow curve by, e.g. stepping up or sweeping stress at an inappropriate rate can lead to highly irreproducible behaviour.
We image the flow of a nearly random close packed, hard-sphere colloidal suspension (a `paste) in a square capillary using confocal microscopy. The flow consists of a `plug in the center while shear occurs localized adjacent to the channel walls, rem
iniscent of yield-stress fluid behavior. However, the observed scaling of the velocity profiles with the flow rate strongly contrasts yield-stress fluid predictions. Instead, the velocity profiles can be captured by a theory of stress fluctuations originally developed for chute flow of dry granular media. We verified this behavior both for smooth and rough boundary conditions.
We review recent advances in imaging the flow of concentrated suspensions, focussing on the use of confocal microscopy to obtain time-resolved information on the single-particle level in these systems. After motivating the need for quantitative (conf
ocal) imaging in suspension rheology, we briefly describe the particles, sample environments, microscopy tools and analysis algorithms needed to perform this kind of experiments. The second part of the review focusses on microscopic aspects of the flow of concentrated model hard-sphere-like suspensions, and the relation to non-linear rheological phenomena such as yielding, shear localization, wall slip and shear-induced ordering. Both Brownian and non-Brownian systems will be described. We show how quantitative imaging can improve our understanding of the connection between microscopic dynamics and bulk flow.
We point out unconventional mechanical properties of confined active fluids, such as bacterial suspensions, under shear. Using a minimal model of an active liquid crystal with no free parameters, we predict the existence of a window of bacteria conce
ntration for which a suspension of textit{E.~Coli} effectively behaves, at steady-state, as a negative viscosity fluid and reach quantitative agreement with experimental measurements. Our theoretical analysis further shows that a negative apparent viscosity is due to a non-monotonic local velocity profile, and is associated with a non-monotonic stress vs. strain rate flow curve. This implies that fixed stress and fixed strain rate ensembles are not equivalent for active fluids.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
