اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدNear Optimal Energy Control and Approximate Capacity of Energy Harvesting Communication
138
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We consider an energy-harvesting communication system where a transmitter powered by an exogenous energy arrival process and equipped with a finite battery of size $B_{max}$ communicates over a discrete-time AWGN channel. We first concentrate on a simple Bernoulli energy arrival process where at each time step, either an energy packet of size $E$ is harvested with probability $p$, or no energy is harvested at all, independent of the other time steps. We provide a near optimal energy control policy and a simple approximation to the information-theoretic capacity of this channel. Our approximations for both problems are universal in all the system parameters involved ($p$, $E$ and $B_{max}$), i.e. we bound the approximation gaps by a constant independent of the parameter values. Our results suggest that a battery size $B_{max}geq E$ is (approximately) sufficient to extract the infinite battery capacity of this channel. We then extend our results to general i.i.d. energy arrival processes. Our approximate capacity characterizations provide important insights for the optimal design of energy harvesting communication systems in the regime where both the battery size and the average energy arrival rate are large.
قيم البحث
اقرأ أيضاً
Energy harvesting multi-hop networks allow for perpetual operation of low cost, limited range wireless devices. Compared with their battery operated counterparts, the coupling of energy and data causality constraints with half duplex relay operation
makes it challenging to operate such networks. In this paper, a throughput maximization problem for energy harvesting two-hop networks with decode-and-forward half-duplex relays is investigated. For a system with two parallel relays, various combinations of the following four transmission modes are considered: Broadcast from the source, multi-access from the relays, and successive relaying phases I and II. Optimal transmission policies for one and two parallel relays are studied under the assumption of non-causal knowledge of energy arrivals and finite size relay data buffers. The problem is formulated using a convex optimization framework, which allows for efficient numerical solutions and helps identify important properties of optimal policies. Numerical results are presented to provide throughput comparisons and to investigate the impact of multiple relays, size of relay data buffers, transmission modes, and energy harvesting on the throughput.
The millimeter wave (mmWave) band, which is a prime candidate for 5G cellular networks, seems attractive for wireless energy harvesting. This is because it will feature large antenna arrays as well as extremely dense base station (BS) deployments. Th
e viability of mmWave for energy harvesting though is unclear, due to the differences in propagation characteristics such as extreme sensitivity to building blockages. This paper considers a scenario where low-power devices extract energy and/or information from the mmWave signals. Using stochastic geometry, analytical expressions are derived for the energy coverage probability, the average harvested power, and the overall (energy-and-information) coverage probability at a typical wireless-powered device in terms of the BS density, the antenna geometry parameters, and the channel parameters. Numerical results reveal several network and device level design insights. At the BSs, optimizing the antenna geometry parameters such as beamwidth can maximize the network-wide energy coverage for a given user population. At the device level, the performance can be substantially improved by optimally splitting the received signal for energy and information extraction, and by deploying multi-antenna arrays. For the latter, an efficient low-power multi-antenna mmWave receiver architecture is proposed for simultaneous energy and information transfer. Overall, simulation results suggest that mmWave energy harvesting generally outperforms lower frequency solutions.
In this paper, the performance of a dual-hop energy harvesting-based fixed-gain amplify-and-forward (AF) relaying communication system, subject to fading impairments, is investigated. We consider a source node ($S$) communicating with a destination n
ode ($D$) through a fixed distant relay ($R$), which harvests energy from its received signals and uses it to amplify and forward the received signals to $D$. Power-splitting (PS) and time-switching (TS) schemes are considered in the analysis for energy harvesting. The $S$-$R$ and $R$-$D$ hops are modeled by the Nakagami-$m$ and $alpha $-$mu $ fading models, respectively. Closed-form expressions for the statistical properties of the end-to-end signal-to-noise ratio (SNR) are derived, based on which novel closed-form expressions for the average symbol error rate (ASER) as well as average channel capacity (ACC) considering four adaptive transmission policies are derived. The derived expressions are validated through Monte-Carlo simulations.
This paper analyzes the communication between two energy harvesting wireless sensor nodes. The nodes use automatic repeat request and forward error correction mechanism for the error control. The random nature of available energy and arrivals of harv
ested energy may induce interruption to the signal sampling and decoding operations. We propose a selective sampling scheme where the length of the transmitted packet to be sampled depends on the available energy at the receiver. The receiver performs the decoding when complete samples of the packet are available. The selective sampling information bits are piggybacked on the automatic repeat request messages for the transmitter use. This way, the receiver node manages more efficiently its energy use. Besides, we present the partially observable Markov decision process formulation, which minimizes the long-term average pairwise error probability and optimizes the transmit power. Optimal and suboptimal power assignment strategies are introduced for retransmissions, which are adapted to the selective sampling and channel state information. With finite battery size and fixed power assignment policy, an analytical expression for the average packet drop probability is derived. Numerical simulations show the performance gain of the proposed scheme with power assignment strategy over the conventional scheme.
The problem of finding decentralized transmission policies in a wireless communication network with energy harvesting constraints is formulated and solved using the decentralized Markov decision process framework. The proposed policy defines the tran
smission probabilities of all devices so as to correctly balance the collision probabilities with the energy constraints. After an initial coordination phase, in which the network parameters are initialized for all devices, every node proceeds in a fully decentralized fashion. We numerically show that, because of the harvesting, a fully orthogonal scheme (e.g., TDMA-like) is sub-optimal in this scenario, and that the optimal trade-off lies between an orthogonal and a completely symmetric system.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
