ترغب بنشر مسار تعليمي؟ اضغط هنا

Surface potential at a ferroelectric grain due to asymmetric screening of depolarization fields

87   0   0.0 ( 0 )
 نشر من قبل Yuri Genenko
 تاريخ النشر 2014
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

Nonlinear screening of electric depolarization fields, generated by a stripe domain structure in a ferroelectric grain of a polycrystalline material, is studied within a semiconductor model of ferroelectrics. It is shown that the maximum strength of local depolarization fields is rather determined by the electronic band gap than by the spontaneous polarization magnitude. Furthermore, field screening due to electronic band bending and due to presence of intrinsic defects leads to asymmetric space charge regions near the grain boundary, which produce an effective dipole layer at the surface of the grain. This results in the formation of a potential difference between the grain surface and its interior of the order of 1 V, which can be of either sign depending on defect transition levels and concentrations. Exemplary acceptor doping of BaTiO3 is shown to allow tuning of the said surface potential in the region between 0.1 and 1.3 V.



قيم البحث

اقرأ أيضاً

Migration of charged point defects triggered by the local random depolarization field is shown to plausibly explain aging of poled ferroelectric ceramics providing reasonable time and acceptor concentration dependences of the emerging internal bias f ield. The theory is based on the evaluation of the energy of the local depolarization field caused by mismatch of the polarizations of neighbor grains. The kinetics of charge migration assumes presence of mobile oxygen vacancies in the material due to the intentional or unintentional acceptor doping. Satisfactory agreement of the theory with experiment on the Fe-doped lead zirconate titanate is demonstrated.
Mobile charges and lattice polarization interact in ferroelectric materials because of the Coulomb interaction between the mobile free charges and the fixed lattice dipoles. We have investigated this mutual screening in KTiOPO4, a ferroelectric/super ionic single crystal in which the mobile charges are K+ ions. The ionic accumulation close to the crystal surfaces leads to orders of magnitude increase of the Second Harmonic Generation. This ionic space charge model is supported by the absence of such an effect in non-ionic conductor but ferroelectric BaTiO3, by its temperature dependence in KTiOPO4 and by its broad depletion at domain walls.
120 - Nicola A. Spaldin 2020
In honor of Igor Dzyaloshinskii on his 90th birthday, we revisit his pioneering work on the linear magnetoelectric effect in light of the modern theory of ferroelectric polarization. We show that the surface magnetic dipole moment associated with mag netoelectric materials is analogous to the bound surface charge in ferroelectrics, in that it can be conveniently described in terms of a bulk magnetoelectric multipolization that is analogous to the ferroelectric polarization. We define the intrinsic surface magnetization to be this surface magnetic dipole moment per unit area, and provide a convenient recipe for extracting it for any surface plane, from knowledge of the bulk magnetic order. We demonstrate the procedure for the prototypical magnetoelectric material, Cr$_2$O$_3$, in which Dzyaloshinskii first identified the linear magnetoelectric effect, and compare the value of the intrinsic surface magnetization to recent experimental measurements. Finally, we argue that non-magnetoelectric antiferromagnets whose multipolization lattices do not contain zero should have an intrinsic surface magnetization, in the same way that non-polar insulators whose polarization lattices do not contain zero have an intrinsic surface charge.
We report active control of the friction force at the contact between a nanoscale asperity and a La$_{0.55}$Ca$_{0.45}$MnO$_3$ (LCMO) thin film using electric fields. We use friction force microscopy under ultrahigh vacuum conditions to measure the f riction force as we change the film resistive state by electric field-induced resistive switching. Friction forces are high in the insulating state and clearly change to lower values when the probed local region is switched to the conducting state. Upon switching back to an insulating state, the friction forces increase again. Thus, we demonstrate active control of friction without having to change the contact temperature or pressure. By comparing with measurements of friction at the metal-to-insulator transition and with the effect of applied voltage on adhesion, we rule out electronic excitations, electrostatic forces and changes in contact area as the reasons for the effect of resistive switching on friction. Instead, we argue that friction is limited by phonon relaxation times which are strongly coupled to the electronic degrees of freedom through distortions of the MnO6 octahedra. The concept of controlling friction forces by electric fields should be applicable to any materials where the field produces strong changes in phonon lifetimes.
Ferroic domain walls could play an important role in microelectronics, given their nanometric size and often distinct functional properties. Until now, devices and device concepts were mostly based on mobile domain walls in ferromagnetic and ferroele ctric materials. A less explored path is to make use of polar domain walls in nonpolar ferroelastic materials. Indeed, while the polar character of ferroelastic domain walls has been demonstrated, polarization control has been elusive. Here, we report evidence for the electrostatic signature of the domain-wall polarization in nonpolar calcium titanate (CaTiO3). Macroscopic mechanical resonances excited by an ac electric field are observed as a signature of a piezoelectric response caused by polar walls. On the microscopic scale, the polarization in domain walls modifies the local surface potential of the sample. Through imaging of surface potential variations, we show that the potential at the domain wall can be controlled by electron injection. This could enable devices based on nondestructive information readout of surface potential.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا