اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدImpact of cation-based localized electronic states on the conduction and valence band structure of AlInN alloys
537
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We demonstrate that cation-related localized states strongly perturb the band structure of $text{Al}_{1-x}text{In}_x$N leading to a strong band gap bowing at low In content. Our first-principles calculations show that In-related localized states are formed both in the conduction and the valence band in $text{Al}_{1-x}text{In}_x$N for low In composition, $x$, and that these localized states dominate the evolution of the band structure with increasing $x$. Therefore, the commonly used assumption of a single composition-independent bowing parameter breaks down when describing the evolution both of the conduction and of the valence band edge in $text{Al}_{1-x}text{In}_x$N.
قيم البحث
اقرأ أيضاً
The nitrogen substitution into the oxygen sites of several oxide materials leads to a reduction of the band gap to the visible light energy range, which makes these oxynitride semiconductors potential photocatalysts for efficient solar water splittin
g. Oxynitrides typically show a different crystal structure compare to the pristine oxide material. Since the band gap is correlated to both the chemical composition and the crystal structure, it is not trivial to distinguish what modifications of the electronic structure induced by the nitrogen substitution are related to compositional and/or structural effects. Here, X-ray emission and absorption spectroscopy is used to investigate the electronic structures of orthorhombic perovskite LaTiOxNy thin films in comparison with films of the pristine oxide LaTiOx with similar orthorhombic structure and cationic oxidation state. Experiment and theory show the expected upward shift in energy of the valence band maximum that reduces the band gap as a consequence of the nitrogen incorporation. But this study also shows that the conduction band minimum, typically considered almost unaffected by the nitrogen substitution, undergoes a significant downward shift in energy. For a rational design of oxynitride photocatalysts the observed changes of both the unoccupied and occupied electronic states have to be taken into account to justify the total band gap narrowing induced by the nitrogen incorporation.
IV-VI semiconductor SnSe has been known as the material with record high thermoelectric performance.The multiple close-to-degenerate valence bands in the electronic band structure has been one of the key factors contributing to the high power factor
and thus figure of merit in the SnSe single crystal. To date, there have been primarily theoretical calculations of this particular electronic band structure. In this paper, however, using angle-resolved photoemission spectroscopy, we perform a systematic investigation of the electronic structure of SnSe. We directly observe three predicted hole bands with small energy differences between their band tops and relatively small in-plane effective masses, in good agreement with the ab initio calculations and critical for the enhancement of the Seebeck coefficient while keeping high electrical conductivity. Our results reveal the complete band structure of SnSe and help to provide a deeper understanding of the electronic origin of the excellent thermoelectric performances in SnSe.
For semiconductors used in photovoltaic devices, the effective mass approximation allows calculation of important material properties from first-principles calculations, including optical properties (e.g. exciton binding energies), defect properties
(e.g. donor and acceptor levels) and transport properties (e.g. carrier mobilities). The conduction and valence bands of semiconductors are commonly approximated as parabolic around their extrema, which gives a simple theoretical description, but ignores the complexity of real materials. In this work, we use density functional theory to assess the impact of band non-parabolicity on four common thin-film photovoltaic materials - GaAs, CdTe, Cu$_2$ZnSnS$_4$ and CH$_3$NH$_3$PbI$_3$ - at temperatures and carrier densities relevant for real-world applications. First, we calculate the effective mass at the band edges. We compare finite-difference, unweighted least-squares and thermally weighted least-squares approaches. We find that the thermally weighted least-squares method reduces sensitivity to the choice of sampling density. Second, we employ a Kane quasi-linear dispersion to quantify the extent of non-parabolicity, and compare results from different electronic structure theories to consider the effect of spin-orbit coupling and electron exchange. Finally, we focus on the halide perovskite CH$_3$NH$_3$PbI$_3$ as a model system to assess the impact of non-parabolicity on calculated electron transport and optical properties at high carrier concentrations. We find that at a concentration of 10$^{20}$ cm$^-3$ the optical effective mass increases by a factor of two relative to the low carrier-concentration value, and the polaron mobility decreases by a factor of three. Our work suggests that similar adjustments should be made to the predicted optical and transport properties of other semiconductors with significant band non-parabolicity.
Angle-resolved photoemission spectroscopy and Auger electron spectroscopy have been applied to study the intercalation process of silver underneath a monolayer of graphite (MG) on Ni(111). The room-temperature deposition of silver on top of MG/Ni(111
) system leads to the islands-like growth of Ag on top of the MG. Annealing of the as-deposited system at temperature of 350-450 C results in the intercalation of about 1-2 ML of Ag underneath MG on Ni(111) independently of the thickness of pre-deposited Ag film (3-100 A). The intercalation of Ag is followed by a shift of the graphite-derived valence band states towards energies which are slightly larger than ones characteristic for pristine graphite. This observation is understood in terms of a weakening of chemical bonding between the MG and the substrate in the MG/Ag/Ni(111) system with a small MG/Ni(111) covalent contribution to this interaction.
We have grown and studied high quality SrRuO3 films grown by MBE as well as PLD. By changing the oxygen activity during deposition we were able to make SrRuO3 samples that were stoichiometric (low oxygen activity) or with ruthenium vacancies (high ox
ygen activity). Samples with strontium vacancies were found impossible to produce since the ruthenium would precipitate out as RuO2. The volume of the unit cell of SrRuO3 becomes larger as more ruthenium vacancies are introduced. The residual resistivity ratio (RRR) and room temperature resistivity were found to systematically depend on the volume of the unit cell and therefore on the amount of ruthenium vacancies. The RRR varied from ~30 for stoichiometric samples to less than two for samples that were very ruthenium poor. The room temperature resistivity varied from 190 microOhm cm for stoichoimetric samples to over 300 microOhm cm for very ruthenium poor samples. UPS spectra show a shift of weight from the coherent peak to the incoherent peak around the Fermi level when samples have more ruthenium vacancies. Core level XPS spectra of the ruthenium 3d lines show a strong screened part in the case of stoichiometric samples. This screened part disappears when ruthenium vacancies are introduced. Both the UPS and the XPS results are consistent with the view that correlation increases as the amount of ruthenium vacancies increase.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
