اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدShear thickening in granular suspensions: inter-particle friction and dynamically correlated clusters
231
0
0.0
(
0
)
تأليف
Claus Heussinger
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We consider the shear rheology of concentrated suspensions of non-Brownian frictional particles. The key result of our study is the emergence of a pronounced shear-thickening regime, where frictionless particles would normally undergo shear-thinning. We clarify that shear thickening in our simulations is due to enhanced energy dissipation via frictional inter-particle forces. Moreover, we evidence the formation of dynamically correlated particle-clusters of size $xi$, which contribute to shear thickening via an increase in emph{viscous} dissipation. A scaling argument gives $etasim xi^2$, which is in very good agreement with the data.
قيم البحث
اقرأ أيضاً
We study the emergence of shear thickening in dense suspensions of non-Brownian particles. We combine local velocity and concentration measurements using Magnetic Resonance Imaging with macroscopic rheometry experiments. In steady state, we observe t
hat the material is heterogeneous, and we find that that the local rheology presents a continuous transition at low shear rate from a viscous to a shear thickening, Bagnoldian, behavior with shear stresses proportional to the shear rate squared, as predicted by a scaling analysis. We show that the heterogeneity results from an unexpectedly fast migration of grains, which we attribute to the emergence of the Bagnoldian rheology. The migration process is observed to be accompanied by macroscopic transient discontinuous shear thickening, which is consequently not an intrinsic property of granular suspensions.
We experimentally investigate the rheology and stress fluctuations of granules densely suspended in silicone oil. We find that both thickening strength and stress fluctuations significantly weaken with oil viscosity $eta_0$. Comparison of our rheolog
ical results to the Wyart-Cates model for describing different dynamic jamming states suggests a transition from frictional contacts to lubrication interactions as $eta_0$ increases. To clarify the contribution from viscous interactions to the rheology, we systematically measure stress fluctuations in various flow states. Reduction of stress fluctuations with $eta_0$ indicates that a strong lubrication layer greatly inhibits force correlations among particles. Measuring stress fluctuations in the strong shear thickening regime, we observe a crossover from asymmetric Gamma to symmetric Gaussian distributions and associated with it a decrease of lateral (radial) correlation length $xi$ with increasing shear rate.
Shear thickening of particle suspensions is characterized by a transition between lubricated and frictional contacts between the particles. Using 3D numerical simulations, we study how the inter-particle friction coefficient influences the effective
macroscopic friction coefficient and hence the microstructure and rheology of dense shear thickening suspensions. We propose expressions for effective friction coefficient in terms of distance to jamming for varying shear stresses and particle friction coefficient values. We find effective friction coefficient to be rather insensitive to interparticle friction, which is perhaps surprising but agrees with recent theory and experiments.
Shear thickening denotes the rapid and reversible increase in viscosity of a suspension of rigid particles under external shear. This ubiquitous phenomenon has been documented in a broad variety of multiphase particulate systems, while its microscopi
c origin has been successively attributed to hydrodynamic interactions and frictional contact between particles. The relative contribution of these two phenomena to the magnitude of shear thickening is still highly debated and we report here a discriminating experimental study using a model shear-thickening suspension that allows us to tune independently both the surface chemistry and the surface roughness of the particles. We show here that both properties matter when it comes to continuous shear thickening (CST) and that the presence of hydrogen bonds between the particles is essential to achieve discontinuous shear thickening (DST) by enhancing solid friction between closely contacting particles. Moreover, a simple argument allows us to predict the onset of CST, which for these highly-textured particles occurs at a critical volume fraction much lower than that previously reported in the literature. Finally, we demonstrate how mixtures of particles with opposing surface chemistry make it possible to finely tune the shear-thickening response of the suspension at a fixed volume fraction, paving the way for a fine control of shear-thickening transition in engineering applications.
Particle-based simulations of discontinuous shear thickening (DST) and shear jamming (SJ) suspensions are used to study the role of stress-activated constraints, with an emphasis on resistance to gear-like rolling. Rolling friction decreases the volu
me fraction required for DST and SJ, in quantitative agreement with real-life suspensions with adhesive surface chemistries and rough particle shapes. It sets a distinct structure of the frictional force network compared to only sliding friction, and from a dynamical perspective leads to an increase in the velocity correlation length, in part responsible for the increased viscosity. The physics of rolling friction is thus a key element in achieving a comprehensive understanding of strongly shear-thickening materials.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
