اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدElectrical switching dynamics and broadband microwave characteristics of VO2 RF devices
133
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Vanadium dioxide is a correlated electron system that features a metal-insulator phase transition (MIT) above room temperature and is of interest in high speed switching devices. Here, we integrate VO2 into two-terminal coplanar waveguides and demonstrate a large resistance modulation of the same magnitude (>10^3) in both electrically (i.e. by bias voltage, referred to as E-MIT) and thermally (T-MIT) driven transitions. We examine transient switching characteristics of the E-MIT and observe two distinguishable time scales for switching. We find an abrupt jump in conductivity with a rise time of the order of 10 ns followed by an oscillatory damping to steady state on the order of several {mu}s. We characterize the RF power response in the On state and find that high RF input power drives VO2 further into the metallic phase, indicating that electromagnetic radiation-switching of the phase transition may be possible. We measure S-parameter RF properties up to 13.5 GHz. Insertion loss is markedly flat at 2.95 dB across the frequency range in the On state and sufficient isolation of over 25 dB is observed in the Off state. We are able to simulate the RF response accurately using both lumped element and 3D electromagnetic models. Extrapolation of our results suggests that optimizing device geometry can reduce insertion loss further and maintain broadband flatness up to 40 GHz.
قيم البحث
اقرأ أيضاً
We have measured the critical phase change conditions induced by electrical pulses in Ge2Sb2Te5 nanopillar phase change memory devices by constructing a comprehensive resistance map as a function of pulse parameters (width, amplitude and trailing edg
e). Our measurements reveal that the heating scheme and the details of the contact geometry play the dominant role in determining the final phase composition of the device such that a non-uniform heating scheme promotes partial amorphization/crystallization for a wide range of pulse parameters enabling multiple resistance levels for data storage applications. Furthermore we find that fluctuations in the snap-back voltage and set/reset resistances in repeated switching experiments are related to the details of the current distribution such that a uniform current injection geometry (i.e. circular contact) favors more reproducible switching parameters. This shows that possible geometrical defects in nanoscale phase change memory devices may play an essential role in the performance of the smallest possible devices through modification of the exact current distribution in the active chalcogenide layer. We present a three-dimensional finite element model of the electro-thermal physics to provide insights into the underlying physical mechanisms of the switching dynamics as well as to quantitatively account for the scaling behaviour of the switching currents in both circular and rectangular contact geometries. The calculated temporal evolution of the heat distribution within the pulse duration shows distinct features in rectangular contacts providing evidence for locally hot spots at the sharp corners of the current injection site due to current crowding effects leading to the observed behaviour.
We report the epitaxial growth and the electrical properties, especially the metal-to-insulator transition (MIT), of vanadium dioxide (VO2) thin films synthesized on LSAT (111) ([LaAlO3]0.3[Sr2AlTaO6]0.7) substrates by pulsed laser deposition. X-ray
diffraction studies show that the epitaxial relationship between the VO2 thin films and LSAT substrate is given as VO2(020)||LSAT(111) and VO2[001]||LSAT[11-2]. We observed a sharp four orders of magnitude change in the longitudinal resistance for the VO2 thin films around the transition temperature. We also measured distinct Raman spectra below and above the transition point indicating a concomitant structural transition between the insulator and metallic phases, in agreement with past investigations.
Traditional electronic devices are well-known to improve in speed and energy-efficiency as their dimensions are reduced to the nanoscale. However, this scaling behavior remains unclear for nonlinear dynamical circuit elements, such as Mott neuron-lik
e spiking oscillators, which are of interest for bio-inspired computing. Here we show that shrinking micrometer-sized VO2 oscillators to sub-100 nm effective sizes, achieved using a nanogap cut in a metallic carbon nanotube (CNT) electrode, does not guarantee faster spiking. However, an additional heat source such as Joule heating from the CNT, in combination with small size and heat capacity (defined by the narrow volume of VO2 whose insulator-metal transition is triggered by the CNT), can increase the spiking frequency by ~1000x due to an electro-thermal bifurcation in the nonlinear dynamics. These results demonstrate that nonlinear dynamical switches operate in a complex phase space which can be controlled by careful electro-thermal design, offering new tuning parameters for designing future biomimetic electronics.
We have investigated the nanoscale switching properties of strain-engineered BiFeO3 thin films deposited on LaAlO3 substrates using a combination of scanning probe techniques. Polarized Raman spectral analysis indicate that the nearly-tetragonal film
s have monoclinic (Cc) rather than P4mm tetragonal symmetry. Through local switching-spectroscopy measurements and piezoresponse force microscopy we provide clear evidence of ferroelectric switching of the tetragonal phase but the polarization direction, and therefore its switching, deviates strongly from the expected (001) tetragonal axis. We also demonstrate a large and reversible, electrically-driven structural phase transition from the tetragonal to the rhombohedral polymorph in this material which is promising for a plethora of applications.
We report on resistive switching of memristive electrochemical metallization devices using 3D kinetic Monte Carlo simulations describing the transport of ions through a solid state electrolyte of an Ag/TiO$_{text{x}}$/Pt thin layer system. The ion tr
ansport model is consistently coupled with solvers for the electric field and thermal diffusion. We show that the model is able to describe not only the formation of conducting filaments but also its dissolution. Furthermore, we calculate realistic current-voltage characteristics and resistive switching kinetics. Finally, we discuss in detail the influence of both the electric field and the local heat on the switching processes of the device.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
