اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدObservation of Pull-in Instability in Graphene Membranes under Interfacial Forces
90
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We present a unique experimental configuration that allows us to determine the interfacial forces on nearly parallel plates made from the thinnest possible mechanical structures, single and few layer graphene membranes. Our approach consists of using a pressure difference across a graphene membrane to bring the membrane to within ~ 10-20 nm above a circular post covered with SiOx or Au until a critical point is reached whereby the membrane snaps into adhesive contact with the post. Continuous measurements of the deforming membrane with an AFM coupled with a theoretical model allow us to deduce the magnitude of the interfacial forces between graphene and SiOx and graphene and Au. The nature of the interfacial forces at ~ 10 - 20 nm separations is consistent with an inverse fourth power distance dependence, implying that the interfacial forces are dominated by van der Waals interactions. Furthermore, the strength of the interactions is found to increase linearly with the number of graphene layers. The experimental approach can be used to measure the strength of the interfacial forces for other atomically thin two-dimensional materials, and help guide the development of nanomechanical devices such as switches, resonators, and sensors.
قيم البحث
اقرأ أيضاً
The electrostatic pull-in instability (EPI), within the framework of the nanoelectromechanical systems (NEMS) has been shown as a robust and versatile method for characterizing mechanical properties of nanocantilevers. This paper aims to investigate
the surface effects, specifically residual surface stress and surface elasticity, on the EPI of micro and nano-scale cantilevers as well as double clamped beams. Since the cantilever has one end free, it has no residual stress, thus the strain-independent component of the surface stress or intrinsic surface stress has no influence on the EPI, as long as it has small deformation. The strain-dependent component of the surface stress or surface elasticity changes the bending stiffness of the cantilever and, consequently, induces shifts in the EPI. For double clamped beams, the effective residual surface stress comes into play and modifies the effective residual stress of the beam. The nonlinear electromechanical coupled equations, which take into account the surface effects are solved numerically. The theoretical results presented in this paper indicate that the EPI is very sensitive to the surface effects, especially when a double clamped beam is employed. The results show that the influence of surface effects on the EPI of cantilevers become more profound when the thickness is below 50 nm, while the influence on double clamped beams is significant even at sub-micron scale. The present study can provide helpful insights for the design and characterization of NEMS switches. Moreover, the results can be used to provide the proof of concepts of a new surface stress sensing method using EPI in nanomechanical sensor systems.
Water transport through graphene-derived membranes has gained much interest recently due to its promising potential in filtration and separation applications. In this work, we explore water permeation in graphene oxide membranes using atomistic simul
ations, by considering flow through interlayer gallery, expanded pores such as wrinkles of interedge spaces, and pores within the sheet. We find that although flow enhancement can be established by nanoconfinement, fast water transport through pristine graphene channels is prohibited by a prominent side-pinning effect from capillaries formed between oxidized regions. We then discuss flow enhancement in situations according to several recent experiments. These understandings are finally integrated into a complete picture to understand water permeation through the layer-by-layer and porous microstructure and could guide rational design of functional membranes for energy and environmental applications.
Motivated by the observation that electrons in graphene, in the hydrodynamic regime of transport, can be treated as a two-dimensional ultra-relativistic gas with very low shear viscosity, we examine the existence of the Rayleigh-Benard instability in
a massless electron-hole plasma. Firstly, we perform a linear stability analysis, derive the leading contributions to the relativistic Rayleigh number, and calculate the critical value above which the instability develops. By replacing typical values for graphene, such as thermal conductivity, shear viscosity, temperature, and sample sizes, we find that the instability might be experimentally observed in the near future. Additionally, we have performed simulations for vanishing reduced chemical potential and compare the measured critical Rayleigh number with the theoretical prediction, finding good agreement.
As mechanical structures enter the nanoscale regime, the influence of van der Waals forces increases. Graphene is attractive for nanomechanical systems because its Youngs modulus and strength are both intrinsically high, but the mechanical behavior o
f graphene is also strongly influenced by the van der Waals force. For example, this force clamps graphene samples to substrates, and also holds together the individual graphene sheets in multilayer samples. Here we use a pressurized blister test to directly measure the adhesion energy of graphene sheets with a silicon oxide substrate. We find an adhesion energy of 0.45 pm 0.02 J/m2 for monolayer graphene and 0.31 pm 0.03 J/m2 for samples containing 2-5 graphene sheets. These values are larger than the adhesion energies measured in typical micromechanical structures and are comparable to solid/liquid adhesion energies. We attribute this to the extreme flexibility of graphene, which allows it to conform to the topography of even the smoothest substrates, thus making its interaction with the substrate more liquid-like than solid-like.
We show that the electromagnetic forces generated by the excitations of a mode in graphene-based optomechanical systems are highly tunable by varying the graphene chemical potential, and orders of magnitude stronger than usual non-graphene-based devi
ces, in both attractive and repulsive regimes. We analyze coupled waveguides made of two parallel graphene sheets, either suspended or supported by dielectric slabs, and study the interplay between the light-induced force and the Casimir-Lifshitz interaction. These findings pave the way to advanced possibilities of control and fast modulation for optomechanical devices and sensors at the nano- and micro-scales.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
