اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدEnhanced Catalytic Activity in Strained Chemically Exfoliated WS2 Nanosheets for Hydrogen Evolution
302
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The ability to efficiently evolve hydrogen via electrocatalysis at low overpotentials holds tremendous promise for clean energy. Hydrogen evolution reaction (HER) can be easily achieved from water if a voltage above the thermodynamic potential of the HER is applied. Large overpotentials are energetically inefficient but can be lowered with expensive platinum based catalysts. Replacement of Pt with inexpensive, earth abundant electrocatalysts would be significantly beneficial for clean and efficient hydrogen evolution. Towards this end, promising HER characteristics have been reported using 2H (trigonal prismatic) XS2 (where X = Mo or W) nanoparticles with a high concentration of metallic edges as electrocatalysts. The key challenges for HER with XS2 are increasing the number and catalytic activity of active sites. Here we report atomically thin nanosheets of chemically exfoliated WS2 as efficient catalysts for hydrogen evolution with very low overpotentials. Atomic-resolution transmission electron microscopy and spectroscopy analyses indicate that enhanced electrocatalytic activity of WS2 is associated with high concentration of strained metallic 1T (octahedral) phase in the as-exfoliated nanosheets. Density functional theory calculations reveal that the presence of strain in the 1T phase leads to an enhancement of the density of states at the Fermi level and increases the catalytic activity of the WS2 nanosheet. Our results suggest that chemically exfoliated WS2 nanosheets could be interesting catalysts for hydrogen evolution.
قيم البحث
اقرأ أيضاً
Chemically and mechanically exfoliated MoS$_2$ single-layer samples have substantially different properties. While mechanically exfoliated single-layers are mono-phase (1H polytype with Mo in trigonal prismatic coordination), the chemically exfoliate
d samples show coexistence of three different phases, 1H, 1T (Mo in octahedral coordination) and 1T$^{}$ (a distorted $2times 1$ 1T-superstructure). By using first-principles calculations, we investigate the energetics and the dynamical stability of the three phases. We show that the 1H phase is the most stable one, while the metallic 1T phase, strongly unstable, undergoes a phase transition towards a metastable and insulating 1T$^{}$ structure composed of separated zig-zag chains. We calculate electronic structure, phonon dispersion, Raman frequencies and intensities for the 1T$^{}$ structure. We provide a microscopical description of the J$_1$, J$_2$ and J$_3$ Raman features first detected more then $20$ years ago, but unexplained up to now. Finally, we show that H adsorbates, that are naturally present at the end of the chemical exfoliation process, stabilize the 1T$^{prime}$ over the 1H one.
We report piezoelectric response in liquid phase exfoliated MoS2 nanosheets with desired structure and morphology. The piezoelectric effect in liquid phase exfoliated few layers of MoS2 flakes is interesting as it may allow the scalable fabrication o
f electronic devices such as self-powered electronics, piezoelectric transformers, antennas and more. The piezo force microscopy (PFM) measurements were used to quantify the amplitude and phase loop, which shows strong piezoelectric coefficient. Herein, the piezoelectric response in few layers of MoS2 is attributed to the defects formed in it during the synthesis procedure. The presence of defects is confirmed by XPS analysis
Monolayers of Transition Metal Dichalcogenides (TMDs) are atomically thin two-dimensional crystals with attractive optoelectronic properties, which are promising for emerging applications in nanophotonics. Here, we report on the extraordinary spatial
non-uniformity of the photoluminescence (PL) and strain properties of WS2 monolayers exfoliated from the natural crystal. Specifically, it is shown that the edges of such monolayers exhibit remarkably enhanced PL intensity compared to their respective central area. A comprehensive analysis of the recombination channels involved in the PL process demonstrates a spatial non-uniformity across the monolayers surface and reflects on the non-uniformity of the intrinsic electron density across the monolayer. Auger electron imaging and spectroscopy studies complemented with PL measurements in different environments indicate that oxygen chemisorption and physisorption are the two fundamental mechanisms responsible for the observed non-uniformity. At the same time Raman spectroscopy analysis shows remarkable strain variations among the different locations of an individual monolayer, however such variations cannot be strictly correlated with the non-uniform PL emission. Our results shed light on the role of the chemical bonding on the competition between exciton complexes in monolayer WS2, providing a way of engineering new nanophotonic functions using WS2 monolayers. It is therefore envisaged that our findings could find diverse applications towards the development of TMDs-based optoelectronic devices.
Laterally large (~3 micrometers), atomically-thin two-dimensional (2D) Bi2O2CO3 nanosheets (2D bismuth oxycarbonate, 2D bismutite) are fabricated via sonochemically-assisted template-free synthesis. Key to the synthesis of the freestanding, laterally
large 2D Bi2O2CO3 nanosheets from bulk Bi powder is choice of suspension medium, controlled reaction temperatures and several hours processing time. Lateral sizes of 2D Bi2O2CO3 can be controlled between micrometer-sized nanosheets and tens of nm sized nanoflakes solely based on the choice of suspension medium. The here introduced 2D Bi2O2CO3 nanosheets/-flakes are then hybridized by a simple mix-and-match approach with TiO2 nanoparticles for testing in suspension-type photocatalytic hydrogen production via water splitting. This introduces the 2D Bi2O2CO3 with TiO2 as a promising noble-metal-free co-catalyst for photocatalytic hydrogen evolution. Our results enrich the fabrication toolbox of emerging 2D pnictogen oxycarbonates towards large 2D nanosheets and demonstrate the promising potential of 2D Bi2O2CO3 as an advantageous (co-)catalyst for hydrogen evolution in photocatalytic water splitting.
Single- and few-layered InSe flakes are produced by the liquid-phase exfoliation of beta-InSe single crystals in 2-propanol, obtaining stable dispersions with a concentration as high as 0.11 g/L. Ultracentrifugation is used to tune the morphology, i.
e., the lateral size and thickness of the as-produced InSe flakes. We demonstrate that the obtained InSe flakes have maximum lateral sizes ranging from 30 nm to a few um, and thicknesses ranging from 1 to 20 nm, with a max population centred at ~ 5 nm, corresponding to 4 Se-In-In-Se quaternary layers. We also show that no formation of further InSe-based compounds (such as In2Se3) or oxides occurs during the exfoliation process. The potential of these exfoliated-InSe few-layer flakes as a catalyst for hydrogen evolution reaction (HER) is tested in hybrid single-walled carbon nanotubes/InSe heterostructures. We highlight the dependence of the InSe flakes morphologies, i.e., surface area and thickness, on the HER performances achieving best efficiencies with small flakes offering predominant edge effects. Our theoretical model unveils the origin of the catalytic efficiency of InSe flakes, and correlates the catalytic activity to the Se vacancies at the edge of the flakes.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
