اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدTheory of magnetic enhancement in strontium hexaferrite through Zn-Sn pair substitution
118
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We study the site occupancy and magnetic properties of Zn-Sn substituted M-type Sr-hexaferrite SrFe$_{12-x}$(Zn$_{0.5}$Sn$_{0.5}$)$_x$O$_{19}$ with x = 1 using first-principles total-energy calculations. We find that in a ground-state configuration Zn-Sn ions preferentially occupy $4f_1$ and $4f_2$ sites unlike the model previously suggested by Ghasemi et al. [J. Appl. Phys, textbf{107}, 09A734 (2010)], where Zn$^{2+}$ and Sn$^{4+}$ ions occupy the $2b$ and $4f_2$ sites. Density-functional theory calculations show that our model has a lower total energy by more than 0.2 eV per unit cell compared to Ghasemis model. More importantly, the latter does not show an increase in saturation magnetization ($M_s$) compared to the pure $M$-type Sr-hexaferrite, in disagreement with the experiment. On the other hand, our model correctly predicts a rapid increase in $M_s$ as well as a decrease in magnetic anisotropy compared to the pure $M$-type Sr-hexaferrite, consistent with experimental measurements.
قيم البحث
اقرأ أيضاً
The site preference and magnetic properties of Zn, Sn and Zn-Sn substituted M-type strontium hexaferrite (SrFe$_{12}$O$_{19}$) have been investigated using first-principles total energy calculations based on density functional theory. The site occupa
ncy of substituted atoms were estimated by calculating the substitution energies of different configurations. The distribution of different configurations during the annealing process at high temperature was determined using the formation probabilities of configurations to calculate magnetic properties of substituted strontium hexaferrite. We found that the magnetization and magnetocrystalline anisotropy are closely related to the distributions of Zn-Sn ions on the five Fe sites. Our calculation show that in SrFe$_{11.5}$Zn$_{0.5}$O$_{19}$, Zn atoms prefer to occupy $4f_1$, $12k$, and $2a$ sites with occupation probability of 78%, 19% and 3%, respectively, while in SrFe$_{11.5}$SnO$_{19}$, Sn atoms occupy the $12k$ and $4f_2$ sites with occupation probability of 54% and 46%, respectively. We also found that in SrFe$_{11}$Zn$_{0.5}$Sn$_{0.5}$O$_{19}$, (Zn,Sn) atom pairs prefer to occupy the ($4f_1$, $4f_2$), ($4f_1$, $12k$) and ($12k$, $12k$) sites with occupation probability of 82%, 8% and 6%, respectively. Our calculation shows that the increase of magnetization and the reduction of magnetic anisotropy in Zn-Sn substituted M-type strontium hexaferrite as observed experimentally is due to the occupation of (Zn,Sn) pairs at the ($4f_1$, $4f_2$) sites.
We use first-principles total-energy calculations based on density functional theory to study the site occupancy and magnetic properties of Al-substituted $M$-type strontium hexaferrite SrFe$_{12-x}$Al$_{x}$O$_{19}$ with $x=0.5$ and $x=1.0$. We find
that the non-magnetic Al$^{3+}$ ions preferentially replace Fe$^{3+}$ ions at two of the majority spin sites, $2a$ and $12k$, eliminating their positive contribution to the total magnetization causing the saturation magnetization $M_s$ to be reduced as Al concentration $x$ is increased. Our formation probability analysis further provides the explanation for increased magnetic anisotropy field when the fraction of Al is increased. Although Al$^{3+}$ ions preferentially occupy the $2a$ sites at a low temperature, the occupation probability of the $12k$ site increases with the rise of the temperature. At a typical annealing temperature ($> 700,^{circ}{rm C}$) Al$^{3+}$ ions are much more likely to occupy the $12k$ site than the $2a$ site. Although this causes the magnetocrystalline anisotropy $K_1$ to be reduced slightly, the reduction in $M_s$ is much more significant. Their combined effect causes the anisotropy field $H_a$ to increase as the fraction of Al is increased, consistent with recent experimental measurements.
The existing quasi-lattice theory for liquid alloys (QLT), which has been extensively used by many researchers, has been modified by incorporating the knowledge of composition and temperature-dependent coordination numbers. The modified QLT was then
used to compute the enthalpy of mixing, the entropy of mixing, concentration fluctuations, Warren-Cowley short range order parameter, surface concentrations and surface tensions of liquid Al-Sn, Al-Zn and Sn-Zn systems, which are the binary sub-systems for Al-Sn-Zn. The effect of the approximation of coordination number in the existing QLT was also investigated and was found to be insignificant when coordination number is 10. This work has provided a more physically realistic quasi-lattice theory, and has contributed to the knowledge on the binary subsystems of Al-Sn-Zn and has also set a foundation for the application of quasi-lattice theory on Al-Sn-Zn and other ternary systems.
Based on the density functional theory with hybrid functional approach, we have studied the structural and thermodynamic stabilities of Cu2MSnX4 (M = Zn, Mg, and Ca; X = S and Se) alloy, and have further investigated the electronic and optical proper
ties of stable Cu2MgSnS4 and Cu2MgSnSe4 phases. Thermal stability analysis indicates that Cu2MgSnS4 and Cu2MgSnSe4 are thermodynamically stable, while Cu2CaSnS4 and Cu2CaSnSe4 are unstable. The ground state configuration of the compound changes from kesterite into stannite structure when Zn atoms are substitued by larger Mg or Ca atoms. An energy separation between stannite and kesterite phase similar to that of CZTS is observed. Calculated electronic structures and optical properties suggest that Cu2MgSnS4 and Cu2MgSnSe4 can be efficient photovoltaic materials.
We have investigated the Vanadium- (V) substituted Ni-Zn-Co ferrites where the samples were prepared using solid-state reaction technique. The impact of V5+ substitution on the structural, magnetic, dielectric and electrical properties of Ni-Zn-Co fe
rrites has been studied. XRD analysis confirmed the formation of a single-phase cubic spinel structure. The lattice constants have been calculated both theoretically and experimentally along with other structural parameters such as bulk density, X-ray density and porosity. The FESEM images are taken to study the surface morphology. FTIR measurement is also performed which confirms spinel structure formation. The saturation magnetization (Ms), coercive field (Hc) and Bohr magneton (B) were calculated from the obtained M-H loops. The temperature dependent permeability is studied to obtain the Curie temperature. Frequency and composition dependence of permeability was also analyzed. Dielectric behavior and ac resistivity are also subjected to investigate the frequency dependency. An inverse relationship was observed between the composition dependence of dielectric constant and ac resistivity. The obtained results such as the electrical resistivity, dielectric constants and magnetic properties suggest the appropriateness of the studied ferrites in microwave device applications.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
