اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدSingle top quark polarization at O(alpha_s) in t t-bar production at a polarized linear e^+ e^- collider
462
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We present a detailed investigation of the NLO polarization of the top quark in t t-bar production at a polarized linear e^+ e^- collider with longitudinally polarized beams. By appropiately tuning the polarization of the beams one can achieve close to maximal values for the top quark polarization over most of the forward hemisphere for a large range of energies. This is quite welcome since the rate is largest in the forward hemisphere. One can also tune the beam polarization to obtain close to zero polarization over most of the forward hemisphere.
قيم البحث
اقرأ أيضاً
We discuss in detail top quark polarization in above-threshold (t bar t)-production at a polarized linear e^+ e^- collider. We pay particular attention to the minimization and maximization of the polarization of the top quark by tuning the longitudin
al polarization of the e^+ and e^- beams. The polarization of the top quark is calculated in full next-to-leading order QCD. We also discuss the beam polarization dependence of the longitudinal spin-spin correlations of the top and antitop quark spins.
We investigate the sensitivity to new physics of the process e+e- -> t bar{t} when the top polarization is analyzed using leptonic final states e+e- -> t bar{t} -> l+l- b bar{b} nu_l bar{nu}_l. We first show that the kinematical reconstruction of the
complete kinematics is experimentally tractable for this process. Then we apply the matrix element method to study the sensitivity to the Vtbar{t} coupling (V being a vector gauge boson), at the tree level and in the narrow width approximation. Assuming the ILC baseline configuration, sqrt{S}=500 GeV, and a luminosity of 500 fb^{-1}, we conclude that this optimal analysis allows to determine simultaneously the ten form factors that parameterize the Vtbar{t} coupling, below the percent level. We also discuss the effects of the next leading order (NLO) electroweak corrections using the GRACE program with polarized beams. It is found that the NLO corrections to different beam polarization lead to significantly different patterns of contributions.
The cross section for the reaction $e^+e^- to tbar{t} H$ depends sensitively on the top quark Yukwawa coupling $lambda_t$. We calculate the rate for $tbar{t}H$ production, followed by the decay $Hto bbar{b}$, for a Standard Model Higgs boson with 100
< m_H <130 GeV. We interface with ISAJET to generate QCD radiation, hadronization and particle decays. We also calculate the dominant $tbar{t}bbar{b}$ backgrounds from electroweak and QCD processes. We consider both semileptonic and fully hadronic decays of the $tbar{t}$ system. In our analysis, we attempt full reconstruction of the top quark and W boson masses in the generated events. The invariant mass of the remaining b-jets should show evidence of Higgs boson production. We estimate the accuracy with which $lambda_t$ can be measured at a linear e^+e^- collider. Our results, including statistical but not systematic errors, show that the top quark Yukawa coupling can be measured to 6-8 % accuracy with 1000 fb^{-1} at $E_{CM}=1 TeV$, assuming 100 % efficiency for b-jet tagging. The accuracy of the measurement drops to 17-22 % if only a 60 % efficiency for b-tagging is achieved.
We present a new derivation of the O(alpha_s) angular distribution of the outgoing $q$-quark in the production process $e^+ e^- togamma,Zto q,bar{q}(g)$. In our calculation, we express the three-particle phase-space integration of the gluon-bremsstra
hlung process in terms of a general set of analytic integral solutions. A consistent treatment of the QCD one-loop corrections to the axial-vector current deserves special attention. This is relevant in the derivation of the forward-backward asymmetry predicted by the standard model. Finally, we provide the full analytical solutions for the differential rates in closed form and conclude with numerical estimates for bottom and top quark production.
We study selectron production at an e-e- linear collider. With the help of transverse beam polarizations, we define CP sensitive observables in the production process e- e- --> selectron_L selectron_R. This process proceeds via t-channel and u-channe
l exchange of neutralinos, and is sensitive to CP violation in the neutralino sector. We present numerical results and estimate the significances to which the CP sensitive observables can be measured.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
