اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدInvestigating the reliability of coronal emission measure distribution diagnostics using 3D radiative MHD simulations
160
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Determining the temperature distribution of coronal plasmas can provide stringent constraints on coronal heating. Current observations with the Extreme ultraviolet Imaging Spectrograph onboard Hinode and the Atmospheric Imaging Assembly onboard the Solar Dynamics Observatory provide diagnostics of the emission measure distribution (EMD) of the coronal plasma. Here we test the reliability of temperature diagnostics using 3D radiative MHD simulations. We produce synthetic observables from the models, and apply the Monte Carlo Markov chain EMD diagnostic. By comparing the derived EMDs with the true distributions from the model we assess the limitations of the diagnostics, as a function of the plasma parameters and of the signal-to-noise of the data. We find that EMDs derived from EIS synthetic data reproduce some general characteristics of the true distributions, but usually show differences from the true EMDs that are much larger than the estimated uncertainties suggest, especially when structures with significantly different density overlap along the line-of-sight. When using AIA synthetic data the derived EMDs reproduce the true EMDs much less accurately, especially for broad EMDs. The differences between the two instruments are due to the: (1) smaller number of constraints provided by AIA data, (2) broad temperature response function of the AIA channels which provide looser constraints to the temperature distribution. Our results suggest that EMDs derived from current observatories may often show significant discrepancies from the true EMDs, rendering their interpretation fraught with uncertainty. These inherent limitations to the method should be carefully considered when using these distributions to constrain coronal heating.
قيم البحث
اقرأ أيضاً
Coronal rain consists of cool and dense plasma condensations formed in coronal loops as a result of thermal instability. Previous numerical simulations of thermal instability and coronal rain formation have relied on artificially adding a coronal hea
ting term to the energy equation. To reproduce large-scale characteristics of the corona, using more realistic coronal heating prescription is necessary. We analyse coronal rain formation and evolution in a 3-dimensional radiative magnetohydrodynamic simulation spanning from convection zone to corona which is self-consistently heated by magnetic field braiding as a result of convective motions. We investigate the spatial and temporal evolution of energy dissipation along coronal loops which become thermally unstable. Ohmic dissipation in the model leads to the heating events capable of inducing sufficient chromospheric evaporation into the loop to trigger thermal instability and condensation formation. The cooling of the thermally unstable plasma occurs on timescales comparable to the duration of the individual impulsive heating events. The impulsive heating has sufficient duration to trigger thermal instability in the loop but does not last long enough to lead to coronal rain limit cycles. We show that condensations can either survive and fall into the chromosphere or be destroyed by strong bursts of Joule heating associated with a magnetic reconnection events. In addition, we find that condensations can also form along open magnetic field lines.
We study the magnetic field and current structure associated with a coronal loop. Through this we investigate to what extent the assumptions of a force-free magnetic field break down and where they might be justified. We analyse a 3D MHD model of the
solar corona in an emerging active region with the focus on the structure of the forming coronal loops. The lower boundary of this simulation is taken from a model of an emerging active region. As a consequence of the emerging magnetic flux and the horizontal motions at the surface a coronal loop forms self-consistently. We investigate the current density along magnetic field inside (and outside) this loop and study the magnetic and plasma properties in and around it. We find that the total current along the loop changes its sign from being antiparallel to parallel to the magnetic field. This is caused by the inclination of the loop together with the footpoint motion. Around the loop the currents form a complex non-force-free helical structure. This is directly related to a bipolar current structure at the loop footpoints at the base of the corona and a local reduction of the background magnetic field (i.e. outside the loop) caused by the plasma flow into and along the loop. The locally reduced magnetic pressure in the loop allows the loop to sustain a higher density, which is crucial for the emission in extreme UV. The acting of the flow on the magnetic field hosting the loop turns out to be also responsible for the observed squashing of the loop. The complex magnetic field and current system surrounding it can be modeled only in 3D MHD models where the magnetic field has to balance the plasma pressure. A 1D coronal loop model or a force-free extrapolation can not capture the current system and the complex interaction of the plasma and the magnetic field in the coronal loop, despite the fact that the loop is under low-$beta$ conditions.
We use Solar Dynamics Observatory (SDO)/Atmospheric Imaging Assembly (AIA) data to reconstruct the plasma properties from differential emission measure (DEM) analysis for a previously studied long-lived, low-latitude coronal hole (CH) over its lifeti
me of ten solar rotations. We initially obtain a non-isothermal DEM distribution with a dominant component centered around 0.9 MK and a secondary smaller component at 1.5 - 2.0 MK. We find that deconvolving the data with the instrument point spread function (PSF) to account for long-range scattered light reduces the secondary hot component. Using the 2012 Venus transit and a 2013 lunar eclipse to test the efficiency of this deconvolution, significant amounts of residual stray light are found for the occulted areas. Accounting for this stray light in the error budget of the different AIA filters further reduces the secondary hot emission, yielding CH DEM distributions that are close to isothermal with the main contribution centered around 0.9 MK. Based on these DEMs, we analyze the evolution of the emission measure (EM), density, and averaged temperature during the CHs lifetime. We find that once the CH is clearly observed in EUV images, the bulk of the CH plasma reveals a quite constant state, i.e. temperature and density reveal no major changes, whereas the total CH area and the photospheric magnetic fine structure inside the CH show a distinct evolutionary pattern. These findings suggest that CH plasma properties are mostly set at the CH formation or/and that all CHs have similar plasma properties.
We present an analysis of the distribution of H-alpha emission measures for the warm ionized medium (WIM) of the Galaxy using data from the Wisconsin H-Alpha Mapper (WHAM) Northern Sky Survey. Our sample is restricted to Galactic latitudes |b| > 10.
We removed sightlines intersecting nineteen high-latititude classical H II regions, leaving only sightlines that sample the diffuse WIM. The distribution of EM sin |b| for the full sample is poorly characterized by a single normal distribution, but is extraordinarily well fit by a lognormal distribution, with <log EM sin |b|> = 0.146 +/- 0.001 and standard deviation 0.190 +/- 0.001. <log EM sin |b|> drops from 0.260 +/- 0.002 at Galactic latitude 10<|b|<30 to 0.038 +/- 0.002 at Galactic latitude 60<|b|<90. The distribution may widen slightly at low Galactic latitude. We compare the observed EM distribution function to the predictions of three-dimensional magnetohydrodynamic simulations of isothermal turbulence within a non-stratified interstellar medium. We find that the distribution of EM sin |b| is well described by models of mildy supersonic turbulence with a sonic Mach number of ~1.4-2.4. The distribution is weakly sensitive to the magnetic field strength. The model also successfully predicts the distribution of dispersion measures of pulsars and H-alpha line profiles. In the best fitting model, the turbulent WIM occupies a vertical path length of 400-500 pc within the 1.0-1.8 kpc scale height of the layer. The WIM gas has a lognormal distribution of densities with a most probable electron density n_{pk} = 0.03 cm^{-3}. We also discuss the implications of these results for interpreting the filling factor, the power requirement, and the magnetic field of the WIM.
It has previously been argued that 1. spicules do not provide enough pre-heated plasma to fill the corona, and 2. even if they did, additional heating would be required to keep the plasma hot as it expands upward. We here address the question of whet
her spicules play an important role by injecting plasma at cooler temperatures ($< 2$ MK), which then gets heated to coronal values at higher altitudes. We measure red-blue asymmetries in line profiles formed over a wide range of temperatures in the bright moss areas of two active regions. We derive emission measure distributions from the excess wing emission. We find that the asymmetries and emission measures are small and conclude that spicules do not inject an important (dominant) mass flux into the cores of active regions at temperatures $> 0.6$ MK ($log T > 5.8$). These conclusions apply not only to spicules, but to any process that suddenly heats and accelerates chromospheric plasma (e.g., a chromospheric nanoflare). The traditional picture of coronal heating and chromospheric evaporation appears to remain the most likely explanation of the active region corona.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
