اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدMacro- and micro-strain in GaN nanowires on Si(111)
190
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We analyze the strain state of GaN nanowire ensembles by x-ray diffraction. The nanowires are grown by molecular beam epitaxy on a Si(111) substrate in a self-organized manner. On a macroscopic scale, the nanowires are found to be free of strain. However, coalescence of the nanowires results in micro-strain with a magnitude from +-0.015% to +-0.03%.This micro-strain contributes to the linewidth observed in low-temperature photoluminescence spectra.
قيم البحث
اقرأ أيضاً
Gallium nitride nanowire and nanorod substrates with different morphology are prospective platforms allowing to control the local strain distribution in graphene films top of them, resulting in an induction of pseudomagnetic fields. Atomic force micr
oscopy measurements performed in a HybriD mode complemented by scanning electron microscopy allow for a detailed visualization of the strain distribution on graphene surface. Graphene in direct contact with supporting regions is tensile strained, while graphene located in-between is characterized by lower strain. Characteristic tensile strained wrinkles also appear in the areas between the supporting regions. A detailed analysis of the strain distribution shows positive correlation between strain gradient and distances between borders of supporting regions. These results are confirmed by Raman spectroscopy by analysis the D band intensity, which is affected by an enhancement of intravalley scattering. Furthermore, scanning tunneling spectroscopy shows a local modification of the density of states near the graphene wrinkle and weak localization measurements indicate the enhancement of pseudomagnetic field-induced scattering. Therefore, we show that nanowire and nanorod substrates provide strain engineering and induction of pseudomagnetic fields in graphene. The control of graphene morphology by a modification of distances between supporting regions is promising for both further fundamental research and the exploration of innovative ways to fabricate pseudomagnetic field-based devices like sensors or filters.
Moderate amount of bending strains, ~3% are enough to induce the semiconductor-metal transition in Si nanowires of ~4nm diameter. The influence of bending on silicon nanowires of 1 nm to 4.3 nm diameter is investigated using molecular dynamics and qu
antum transport simulations. Local strains in nanowires are analyzed along with the effect of bending strain and nanowire diameter on electronic transport and the transmission energy gap. Interestingly, relatively wider nanowires are found to undergo semiconductor-metal transition at relatively lower bending strains. The effect of bending strain on electronic properties is then compared with the conventional way of straining, i.e. uniaxial, which shows that, the bending is much more efficient way of straining to enhance the electronic transport and also to induce the semiconductor-metal transition in experimentally realizable Si nanowires.
Conducting nanowires possess remarkable physical properties unattainable in bulk materials. However our understanding of their transport properties is limited by the difficulty of connecting them electrically. In this Letter we investigate phototrans
port in both bulk silicon and silicon nanowires using a superconducting multimode resonator operating at frequencies between 0.3 and 3 GHz. We find that whereas the bulk Si response is mainly dissipative, the nanowires exhibit a large dielectric polarizability. This technique is contactless and can be applied to many other semiconducting nanowires and molecules. Our approach also allows to investigate the coupling of electron transport to surface acoustic waves in bulk Si and to electro-mechanical resonances in the nanowires.
We investigate the strain state of ensembles of thin and nearly coalescence-free self-assembled GaN nanowires prepared by plasma-assisted molecular beam epitaxy on Ti/Al$_{2}$O$_{3}(0001)$ substrates. The shifts of Bragg peaks in high-resolution X-ra
y diffraction profiles reveal the presence of a homogeneous tensile strain in the out-of-plane direction. This strain is inversely proportional to the average nanowire radius and results from the surface stress acting on the nanowire sidewalls. The superposition of strain from nanowires with different radii in the same ensemble results in a broadening of the Bragg peaks that mimics an inhomogeneous strain on a macroscopic scale. The nanowire ensembles show a small blueshift of the bound-exciton transitions in photoluminescence spectra, reflecting the existence of a compensating in-plane compressive strain, as further supported by grazing incidence x-ray diffraction measurements carried out at a synchrotron. By combining X-ray diffraction and photoluminescence spectroscopy, the surface stress components $f_{x}$ and $f_{z}$ of the air-exposed GaN${1bar100}$ planes that constitute the nanowire sidewalls are determined experimentally to be 2.25 and $-0.7$~N/m, respectively.
Small-angle X-ray scattering from GaN nanowires grown on Si(111) is studied experimentally and modeled by means of Monte Carlo simulations. It is shown that the scattering intensity at large wave vectors does not follow Porods law $I(q)propto q^{-4}$
. The intensity depends on the orientation of the side facets with respect to the incident X-ray beam. It is maximum when the scattering vector is directed along a facet normal, as a reminiscence of the surface truncation rod scattering. At large wave vectors $q$, the scattering intensity is found to be decreased by surface roughness. A root mean square roughness of 0.9~nm, which is the height of just 3--4 atomic steps per micron long facet, already gives rise to a strong intensity reduction.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
