اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدSpurious Shear in Weak Lensing with LSST
277
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The complete 10-year survey from the Large Synoptic Survey Telescope (LSST) will image $sim$ 20,000 square degrees of sky in six filter bands every few nights, bringing the final survey depth to $rsim27.5$, with over 4 billion well measured galaxies. To take full advantage of this unprecedented statistical power, the systematic errors associated with weak lensing measurements need to be controlled to a level similar to the statistical errors. This work is the first attempt to quantitatively estimate the absolute level and statistical properties of the systematic errors on weak lensing shear measurements due to the most important physical effects in the LSST system via high fidelity ray-tracing simulations. We identify and isolate the different sources of algorithm-independent, textit{additive} systematic errors on shear measurements for LSST and predict their impact on the final cosmic shear measurements using conventional weak lensing analysis techniques. We find that the main source of the errors comes from an inability to adequately characterise the atmospheric point spread function (PSF) due to its high frequency spatial variation on angular scales smaller than $sim10$ in the single short exposures, which propagates into a spurious shear correlation function at the $10^{-4}$--$10^{-3}$ level on these scales. With the large multi-epoch dataset that will be acquired by LSST, the stochastic errors average out, bringing the final spurious shear correlation function to a level very close to the statistical errors. Our results imply that the cosmological constraints from LSST will not be severely limited by these algorithm-independent, additive systematic effects.
قيم البحث
اقرأ أيضاً
Residual errors in shear measurements, after corrections for instrument systematics and atmospheric effects, can impact cosmological parameters derived from weak lensing observations. Here we combine convergence maps from our suite of ray-tracing sim
ulations with random realizations of spurious shear. This allows us to quantify the errors and biases of the triplet $(Omega_m,w,sigma_8)$ derived from the power spectrum (PS), as well as from three different sets of non-Gaussian statistics of the lensing convergence field: Minkowski functionals (MF), low--order moments (LM), and peak counts (PK). Our main results are: (i) We find an order of magnitude smaller biases from the PS than in previous work. (ii) The PS and LM yield biases much smaller than the morphological statistics (MF, PK). (iii) For strictly Gaussian spurious shear with integrated amplitude as low as its current estimate of $sigma^2_{sys}approx 10^{-7}$, biases from the PS and LM would be unimportant even for a survey with the statistical power of LSST. However, we find that for surveys larger than $approx 100$ deg$^2$, non-Gaussianity in the noise (not included in our analysis) will likely be important and must be quantified to assess the biases. (iv) The morphological statistics (MF,PK) introduce important biases even for Gaussian noise, which must be corrected in large surveys. The biases are in different directions in $(Omega_m,w,sigma_8)$ parameter space, allowing self-calibration by combining multiple statistics. Our results warrant follow-up studies with more extensive lensing simulations and more accurate spurious shear estimates.
3D data compression techniques can be used to determine the natural basis of radial eigenmodes that encode the maximum amount of information in a tomographic large-scale structure survey. We explore the potential of the Karhunen-Lo`eve decomposition
in reducing the dimensionality of the data vector for cosmic shear measurements, and apply it to the final data from the cfh survey. We find that practically all of the cosmological information can be encoded in one single radial eigenmode, from which we are able to reproduce compatible constraints with those found in the fiducial tomographic analysis (done with 7 redshift bins) with a factor of ~30 fewer datapoints. This simplifies the problem of computing the two-point function covariance matrix from mock catalogues by the same factor, or by a factor of ~800 for an analytical covariance. The resulting set of radial eigenfunctions is close to ell-independent, and therefore they can be used as redshift-dependent galaxy weights. This simplifies the application of the Karhunen-Lo`eve decomposition to real-space and Fourier-space data, and allows one to explore the effective radial window function of the principal eigenmodes as well as the associated shear maps in order to identify potential systematics. We also apply the method to extended parameter spaces and verify that additional information may be gained by including a second mode to break parameter degeneracies. The data and analysis code are publicly available at https://github.com/emiliobellini/kl_sample.
Metacalibration is a recently introduced method to accurately measure weak gravitational lensing shear using only the available imaging data, without need for prior information about galaxy properties or calibration from simulations. The method invol
ves distorting the image with a small known shear, and calculating the response of a shear estimator to that applied shear. The method was shown to be accurate in moderate sized simulations with galaxy images that had relatively high signal-to-noise ratios, and without significant selection effects. In this work we introduce a formalism to correct for both shear response and selection biases. We also observe that, for images with relatively low signal-to-noise ratios, the correlated noise that arises during the metacalibration process results in significant bias, for which we develop a simple empirical correction. To test this formalism, we created large image simulations based on both parametric models and real galaxy images, including tests with realistic point-spread functions. We varied the point-spread function ellipticity at the five percent level. In each simulation we applied a small, few percent shear to the galaxy images. We introduced additional challenges that arise in real data, such as detection thresholds, stellar contamination, and missing data. We applied cuts on the measured galaxy properties to induce significant selection effects. Using our formalism, we recovered the input shear with an accuracy better than a part in a thousand in all cases.
We present results from a set of simulations designed to constrain the weak lensing shear calibration for the Hyper Suprime-Cam (HSC) survey. These simulations include HSC observing conditions and galaxy images from the Hubble Space Telescope (HST),
with fully realistic galaxy morphologies and the impact of nearby galaxies included. We find that the inclusion of nearby galaxies in the images is critical to reproducing the observed distributions of galaxy sizes and magnitudes, due to the non-negligible fraction of unrecognized blends in ground-based data, even with the excellent typical seeing of the HSC survey (0.58 in the $i$-band). Using these simulations, we detect and remove the impact of selection biases due to the correlation of weights and the quantities used to define the sample (S/N and apparent size) with the lensing shear. We quantify and remove galaxy property-dependent multiplicative and additive shear biases that are intrinsic to our shear estimation method, including a $sim 10$ per cent-level multiplicative bias due to the impact of nearby galaxies and unrecognized blends. Finally, we check the sensitivity of our shear calibration estimates to other cuts made on the simulated samples, and find that the changes in shear calibration are well within the requirements for HSC weak lensing analysis. Overall, the simulations suggest that the weak lensing multiplicative biases in the first-year HSC shear catalog are controlled at the 1 per cent level.
We present an analysis of the impact of the tree rings seen in the candidate sensors of the Large Synoptic Survey Telescope (LSST) on galaxy-shape measurements. The tree rings are a consequence of transverse electric fields caused by circularly symme
tric impurity gradients in the silicon of the sensors. They effectively modify the pixel area and shift the photogenerated charge around, displacing the observed photon positions. The displacement distribution generates distortions that cause spurious shears correlated with the tree-rings patterns, potentially biasing cosmic shear measurements. In this paper we quantify the amplitude of the spurious shear caused by the tree rings on the LSST candidate sensors, and calculate its 2-point correlation function. We find that 2-point correlation function of the spurious shear on an area equivalent to the LSST field of view is order of about $10^{-13}$, providing a negligible contribution to the 2-point correlation of the cosmic shear signal. Additional work is underway, and the final results and analysis will be published elsewhere (Okura et al. (2015), in prep.)
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
