اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدThe characterization of Virgo data and its impact on gravitational-wave searches
130
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Between 2007 and 2010 Virgo collected data in coincidence with the LIGO and GEO gravitational-wave (GW) detectors. These data have been searched for GWs emitted by cataclysmic phenomena in the universe, by non-axisymmetric rotating neutron stars or from a stochastic background in the frequency band of the detectors. The sensitivity of GW searches is limited by noise produced by the detector or its environment. It is therefore crucial to characterize the various noise sources in a GW detector. This paper reviews the Virgo detector noise sources, noise propagation, and conversion mechanisms which were identified in the three first Virgo observing runs. In many cases, these investigations allowed us to mitigate noise sources in the detector, or to selectively flag noise events and discard them from the data. We present examples from the joint LIGO-GEO-Virgo GW searches to show how well noise transients and narrow spectral lines have been identified and excluded from the Virgo data. We also discuss how detector characterization can improve the astrophysical reach of gravitational-wave searches.
قيم البحث
اقرأ أيضاً
Long-lived gravitational wave (GW) transients have received interest in the last decade, as the sensitivity of LIGO and Virgo increases. Such signals, lasting between 10 and 1000s, can come from a variety of sources, including accretion disk instabil
ities around black holes, binary neutron stars post-merger, core-collapse supernovae, non-axisymmetric deformations in isolated neutron stars, and magnetar giant flares. Given the large parameter space and the lack of precisely modeled waveforms, searches must rely on robust detection algorithms, which make few or no assumptions on the nature of the signal. Here we present a new data analysis pipeline to search for long-lived transient GW signals, based on an excess cross-power statistic computed over a network of detectors. It uses a hierarchical strategy that allows to estimate the background quickly and implements several features aimed to increase detection sensitivity by 30% for a wide range of signal morphology compared to an older implementation. We also report upper limits on the GW energy emitted from a search conducted with the pipeline for GW emission around a sample of nearby magnetar giant flares, and discuss detection potential of such sources with second and third-generation detectors.
The field of gravitational-wave astronomy has been opened up by gravitational-wave observations made with interferometric detectors. This review surveys the current state-of-the-art in gravitational-wave detectors and data analysis methods currently
used by the Laser Interferometer Gravitational-Wave Observatory in the United States and the Virgo Observatory in Italy. These analysis methods will also be used in the recently completed KAGRA Observatory in Japan. Data analysis algorithms are developed to target one of four classes of gravitational waves. Short duration, transient sources include compact binary coalescences, and burst sources originating from poorly modelled or unanticipated sources. Long duration sources include sources which emit continuous signals of consistent frequency, and many unresolved sources forming a stochastic background. A description of potential sources and the search for gravitational waves from each of these classes are detailed.
The search procedure for burst gravitational waves has been studied using 24 hours of simulated data in a network of three interferometers (Hanford 4-km, Livingston 4-km and Virgo 3-km are the example interferometers). Several methods to detect burst
events developed in the LIGO Scientific Collaboration (LSC) and Virgo collaboration have been studied and compared. We have performed coincidence analysis of the triggers obtained in the different interferometers with and without simulated signals added to the data. The benefits of having multiple interferometers of similar sensitivity are demonstrated by comparing the detection performance of the joint coincidence analysis with LSC and Virgo only burst searches. Adding Virgo to the LIGO detector network can increase by 50% the detection efficiency for this search. Another advantage of a joint LIGO-Virgo network is the ability to reconstruct the source sky position. The reconstruction accuracy depends on the timing measurement accuracy of the events in each interferometer, and is displayed in this paper with a fixed source position example.
A search for gravitational wave burst events has been performed with the Virgo C7 commissioning run data that have been acquired in September 2005 over five days. It focused on un-modeled short duration signals in the frequency range 150 Hz to 2 kHz.
A search aimed at detecting the GW emission from the merger and ringdown phases of binary black hole coalescences was also carried out. An extensive understanding of the data was required to be able to handle a burst search using the output of only one detector. A 90% confidence level upper limit on the number of expected events given the Virgo C7 sensitivity curve has been derived as a function of the signal strength, for un-modeled gravitational wave search. The sensitivity of the analysis presented is, in terms of the root sum square strain amplitude, $h_{rss} simeq 10^{-20} / sqrt{Hz}$. This can be interpreted in terms of a frequentist upper limit on the rate ${cal{R}}_{90%}$ of detectable gravitational wave bursts at the level of 1.1 events per day at 90% confidence level. From the binary black hole search, we obtained the distance reach at 50% and 90% efficiency as a function of the total mass of the final black hole. The maximal detection distance for non-spinning high and equal mass black hole binary system obtained by this analysis in C7 data is $simeq$ 2.9 $pm$ 0.1 Mpc for a detection efficiency of 50% for a binary of total mass $80 M_{odot}$.
The possible formation of stellar-mass binary black holes through dynamical interactions in dense stellar environments predicts the existence of binaries with non-negligible eccentricity in the frequency band of ground-based gravitational wave detect
ors; the detection of binary black hole mergers with measurable orbital eccentricity would validate the existence of this formation channel. Waveform templates currently used in the matched-filter gravitational-wave searches of LIGO-Virgo data neglect effects of eccentricity which is expected to reduce their efficiency to detect eccentric binary black holes. Meanwhile, the sensitivity of coherent unmodeled gravitational-wave searches (with minimal assumptions about the signal model) have been shown to be largely unaffected by the presence of even sizable orbital eccentricity. In this paper, we compare the performance of two state-of-the-art search algorithms recently used by LIGO and Virgo to search for binary black holes in the second Observing Run (O2), quantifying their search sensitivity by injecting numerical-relativity simulations of inspiral-merger-ringdown eccentric waveforms into O2 LIGO data. Our results show that the matched-filter search PyCBC performs better than the unmodeled search cWB for the high chirp mass ($>20 M_{odot}$) and low eccentricity region ($e_{30 Hz} < 0.3$) of parameter space. For moderate eccentricities and low chirp mass, on the other hand, the unmodeled search is more sensitive than the modeled search.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
