اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدIntroduction of Zr in nanometric periodic Mg/Co multilayers
93
0
0.0
(
0
)
تأليف
K. Le Guen
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We study the introduction of a third material, namely Zr, within a nanometric periodic Mg/Co structure designed to work as optical component in the extreme UV (EUV) spectral range. Mg/Co, Mg/Zr/Co, Mg/Co/Zr and Mg/Zr/Co/Zr multilayers are designed, then characterized in terms of structural quality and optical performances through X-ray and EUV reflectometry measurements respectively. For the Mg/Co/Zr structure, the reflectance value is equal to 50% at 25.1 nm and 45deg of grazing incidence and reaches 51.3% upon annealing at 200deg C. Measured EUV reflectivity values of tri-layered systems are discussed in terms of material order within a period and compared to the predictions of the theoretical model of Larruquert. Possible applications are pointed out.
قيم البحث
اقرأ أيضاً
We present the results of the characterization of Mg/Co periodic multilayers and their thermal stability for the EUV range. The annealing study is performed up to a temperature of 400degree C. Images obtained by scanning transmission electron microsc
opy and electron energy loss spectroscopy clearly show the good quality of the multilayer structure. The measurements of the EUV reflectivity around 25 nm (~49 eV) indicate that the reflectivity decreases when the annealing temperature increases above 300degreeC. X-ray emission spectroscopy is performed to determine the chemical state of the Mg atoms within the Mg/Co multilayer. Nuclear magnetic resonance used to determine the chemical state of the Co atoms and scanning electron microscopy images of cross sections of the Mg/Co multilayers reveal changes in the morphology of the stack from an annealing temperature of 305degreee;C. This explains the observed reflectivity loss.
The resonant magnetic reflectivity of Co/Mg multilayers around the Co L2,3 absorption edge is simulated then measured on a specifically designed sample. The dichroic signal is obtained when making the difference between the two reflectivities measure
d with the magnetic field applied in two opposite directions parallel to the sample surface. The simulations show that the existence of magnetic dead layers at the interfaces between the Co and Mg layers leads to an important increase of the dichroic signal measured in the vicinity of the third Bragg peak that otherwise should be negligible. The measurements are in agreement with the model introducing 0.25 nm thick dead layers. This is attributed to the Co atoms in contact with the Mg layers and thus we conclude that the Co-Mg interfaces are abrupt from the magnetic point of view.
Depth-grading of magnetic anisotropy in perpendicular magnetic media has been predicted to reduce the field required to write data without sacrificing thermal stability. To study this prediction, we have produced Co/Pd multilayers with depth-dependen
t Co layer thickness. Polarized neutron reflectometry shows that the thickness grading results in a corresponding magnetic anisotropy gradient. Magnetometry reveals that the anisotropy gradient promotes domain nucleation upon magnetization reversal - a clear experimental demonstration of the effectiveness of graded anisotropy for reducing write-field.
We have studied the magnetic properties of multilayers composed of ferromagnetic metal Co and heavy metals with strong spin orbit coupling (Pt and Ir). Multilayers with symmetric (ABA stacking) and asymmetric (ABC stacking) structures are grown to st
udy the effect of broken structural inversion symmetry. We compare the perpendicular magnetic anisotropy (PMA) energy of symmetric Pt/Co/Pt, Ir/Co/Ir multilayers and asymmetric Pt/Co/Ir, Ir/Co/Pt multilayers. First, the interface contribution to the PMA is studied using the Co layer thickness dependence of the effective PMA energy. Comparison of the interfacial PMA between the Ir/Co/Pt, Pt/Co/Ir asymmetric structures and Pt/Co/Pt, Ir/Co/Ir symmetric structures indicate that the broken structural inversion symmetry induced PMA is small compared to the overall interfacial PMA. Second, we find the magnetic anisotropy field is significantly increased in multilayers when the ferromagnetic layers are antiferromagnetically coupled via interlayer exchange coupling (IEC). Macrospin model calculations can qualitatively account for the relation between the anisotropy field and the IEC. Among the structures studied, IEC is the largest for the asymmetric Ir/Co/Pt multilayers: the exchange coupling field exceeds 3 T and consequently, the anisotropy field approaches 10 T. Third, comparing the asymmetric Ir/Co/Pt and Pt/Co/Ir structures, we find the IEC and, to some extent, the interface PMA are stronger for the former than the latter. X-ray magnetic circular dichroism studies suggest that the proximity induced magnetization in Pt is larger for the Ir/Co/Pt multilayers than the inverted structure, which may partly account for the difference in the magnetic properties. These results show the intricate relation between PMA, IEC and the proximity induced magnetization that can be exploited to design artificial structures with unique magnetic characteristics.
Mg-Ti alloys have uncommon optical and hydrogen absorbing properties, originating from a spinodal-like microstructure with a small degree of chemical short-range order in the atoms distribution. In the present study we artificially engineer short-ran
ge order by depositing Pd-capped Mg/Ti multilayers with different periodicities and characterize them both structurally and optically. Notwithstanding the large lattice parameter mismatch between Mg and Ti, the as-deposited metallic multilayers show good structural coherence. Upon exposure to H2 gas a two-step hydrogenation process occurs, with the Ti layers forming the hydride before Mg. From in-situ measurements of the bilayer thickness L at different hydrogen pressures, we observe large out-of-plane expansions of the Mg and Ti layers upon hydrogenation, indicating strong plastic deformations in the films and a consequent shortening of the coherence length. Upon unloading at room temperature in air, hydrogen atoms remain trapped in the Ti layers due to kinetic constraints. Such loading/unloading sequence can be explained in terms of the different thermodynamic properties of hydrogen in Mg and Ti, as shown by diffusion calculations on a model multilayered systems. Absorption isotherms measured by hydrogenography can be interpreted as a result of the elastic clamping arising from strongly bonded Mg/Pd and broken Mg/Ti interfaces.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
