اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدEstimation of the spin polarization for Heusler-compound thin films by means of nonlocal spin-valve measurements: Comparison of Co$_{2}$FeSi and Fe$_{3}$Si
93
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We study room-temperature generation and detection of pure spin currents using lateral spin-valve devices with Heusler-compound electrodes, Co$_{2}$FeSi (CFS) or Fe$_{3}$Si (FS). The magnitude of the nonlocal spin-valve (NLSV) signals is seriously affected by the dispersion of the resistivity peculiarly observed in the low-temperature grown Heusler compounds with ordered structures. From the analysis based on the one-dimensional spin diffusion model, we find that the spin polarization monotonically increases with decreasing the resistivity, which depends on the structural ordering, for both CFS and FS electrodes, and verify that CFS has relatively large spin polarization compared with FS.
قيم البحث
اقرأ أيضاً
Using low-temperature molecular beam epitaxy, we study substitutions of Fe atoms for Co ones in Co_3-xFe_xSi Heusler-compound films grown on Si and Ge. Even for the low-temperature grown Heusler-compound films, the Co-Fe atomic substitution at A and
C sites can be confirmed by the conversion electron Mossbauer spectroscopy measurements. As a result, the magnetic moment and room-temperature spin polarization estimated by nonlocal spin-valve measurements are systematically changed with the Co-Fe substitutions. This study experimentally verified that the Co-Fe substitution in Co_3-xFe_xSi Heusler compounds can directly affect the room-temperature spin polarization.
Fe-Si binary compounds have been fabricated by focused electron beam induced deposition by the alternating use of iron pentacarbonyl, Fe(CO)5, and neopentasilane, Si5H12 as precursor gases. The fabrication procedure consisted in preparing multilayer
structures which were treated by low-energy electron irradiation and annealing to induce atomic species intermixing. In this way we are able to fabricate FeSi and Fe3Si binary compounds from [Fe=Si]2 and [Fe3=Si]2 multilayers, as shown by transmission electron microscopy investigations. This fabrication procedure is useful to obtain nanostructured binary alloys from precursors which compete for adsorption sites during growth and, therefore, cannot be used simultaneously.
In spin transport experiments with spin currents propagating through antiferromagnetic (AFM) material, the antiferromagnet is treated as a mainly passive spin conductor not generating nor adding any spin current to the system. The spin current transm
issivity of the AFM NiO is affected by magnetic fluctuations, peaking at the Neel temperature and decreasing by lowering the temperature. In order to study the role of the AFM in local and nonlocal spin transport experiments, we send spin currents through NiO of various thickness placed on Y$_3$Fe$_5$O$_{12}$. The spin currents are injected either electrically or by thermal gradients and measured at a wide range of temperatures and magnetic field strengths. The transmissive role is reflected in the sign change of the local electrically injected signals and the decrease in signal strength of all other signals by lowering the temperature. The thermally generated signals, however, show an additional upturn below 100$,$K which are unaffected by an increased NiO thickness. A change in the thermal conductivity could affect these signals. The temperature and magnetic field dependence is similar as for bulk NiO, indicating that NiO itself contributes to thermally induced spin currents.
Ferromagnetic resonance (FMR) technique has been used to study the magnetization relaxation processes and magnetic anisotropy in two different series of the Co2FeSi (CFS) Heusler alloy thin films, deposited on the Si(111) substrate by UHV sputtering.
While the CFS films of fixed (50 nm) thickness, deposited at different substrate temperatures (TS) ranging from room temperature (RT) to 600^C, constitute the series-I, the CFS films with thickness t varying from 12 nm to 100 nm and deposited at 550^C make up the series-II. In series-I, the CFS films deposited at TS = RT and 200^C are completely amorphous, the one at TS = 300^C is partially crystalline, and those at TS equal 450^C, 550^C and 600^C are completely crystalline with B2 order. By contrast, all the CFS films in series-II are in the fully-developed B2 crystalline state. Irrespective of the strength of disorder and film thickness, angular variation of the resonance field in the film plane unambiguously establishes the presence of global in-plane uniaxial anisotropy. Angular variation of the linewidth in the film plane reveals that, in the CFS thin films of varying thickness, a crossover from the in-plane local four-fold symmetry (cubic anisotropy) to local two-fold symmetry (uniaxial anisotropy) occurs as t exceeds 50 nm. Gilbert damping parameter {alpha} decreases monotonously from 0.047 to 0.0078 with decreasing disorder strength (increasing TS) and jumps from 0.008 for the CFS film with t = 50 nm to 0.024 for the film with t equal 75 nm. Such variations of {alpha} with TS and t are understood in terms of the changes in the total (spin-up and spin-down) density of states at the Fermi level caused by the disorder and film thickness.
We demonstrate first measurements of successful spin generation in crystalline Co$_2$FeSi/MgO/GaAs hybrid structures grown by molecular-beam epitaxy (MBE), with different MgO interlayer thicknesses. Using non-local spin valve and non-local Hanle meas
urement configurations, we determine spin lifetimes of ${tau approx 100}$~ns and spin diffusion lengths of ${lambda approx 5.6}$~$mu$m for different MgO layer thicknesses proving the high quality of the GaAs transport channel. For an optimized MgO layer thickness, the bias dependence of the spin valve signals indicates the verification of the half-metallic gap (upper edge) of Co$_2$FeSi in accordance with first principle calculations. In addition to that, spin generation efficiencies up to 18$%$ reveal the high potential of MgO interlayers at the Co$_2$FeSi/GaAs interface for further device applications.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
