اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدStudy of phase stability in the $sigma$-FeCr system
174
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Formation energy of the $sigma$-phase in the Fe-Cr alloy system, $Delta E$, was computed versus the occupancy changes on each of the five possible lattice sites. Its dependence on a number of Fe-atoms per unit cell, $N_{Fe}$, was either monotonically increasing or decreasing function of $N_{Fe}$, depending on the site on which Fe-occupancy was changed. Based on the calculated $Delta E$ - values, the average formation energy, $<Delta E>$, was determined as a weighted over probabilities of different atomic configurations. The latter has a minimum in the concentration range where the $sigma$-phase exists. The minimum in that range of composition was also found for the free energy calculated for 2000 K and taking only the configurational entropy into account.
قيم البحث
اقرأ أيضاً
Understanding the mechanisms of plasticity in structural steels is essential for the operation of next-generation fusion reactors. Elemental composition, particularly the amount of Cr present, and irradiation can have separate and synergistic effects
on the mechanical properties of ferritic/martensitic steels. The study of ion-irradiated FeCr alloys is useful for gaining a mechanistic understanding of irradiation damage in steels. Previous studies of ion-irradiated FeCr did not clearly distinguish between the nucleation of dislocations to initiate plasticity, and their propagation through the material as plasticity progresses. In this study, Fe3Cr, Fe5Cr, and Fe10Cr were irradiated with 20 MeV Fe$^{3+}$ ions at room temperature to nominal doses of 0.01 dpa and 0.1 dpa. Nanoindentation was carried out with Berkovich and spherical indenter tips to study the nucleation of dislocations and their subsequent propagation. The presence of irradiation-induced defects reduced the theoretical shear stress and barrier for dislocation nucleation. The presence of Cr further enhanced this effect due to increased retention of irradiation defects. However, this combined effect is still small compared to dislocation nucleation from pre-existing sources such as Frank-Read sources and grain boundaries. The yield strength, an indicator of dislocation mobility, of FeCr increased with irradiation damage and Cr. The increased retention of irradiation defects due to the presence of Cr also further increased the yield strength. Reduced work hardening capacity was also observed following irradiation. The synergistic effects of Cr and irradiation damage in FeCr appear to be more important for the propagation of dislocations, rather than their nucleation.
Ab-initio density functional theory (DFT) calculations of the relative stability of anatase and rutile polymorphs of TiO2 were carried using all-electron atomic orbitals methods with local density approximation (LDA). The rutile phase exhibited a mod
erate margin of stability of ~ 3 meV relative to the anatase phase in pristine material. From computational analysis of the formation energies of Si, Al, Fe and F dopants of various charge states across different Fermi level energies in anatase and in rutile, it was found that the cationic dopants are most stable in Ti substitutional lattice positions while formation energy is minimised for F- doping in interstitial positions. All dopants were found to considerably stabilise anatase relative to the rutile phase, suggesting the anatase to rutile phase transformation is inhibited in such systems with the dopants ranked F>Si>Fe>Al in order of anatase stabilisation strength. Al and Fe dopants were found to act as shallow acceptors with charge compensation achieved through the formation of mobile carriers rather than the formation of anion vacancies.
X-ray diffraction (XRD) and Mossbauer spectroscopy techniques combined with theoretical calculations based on the Korringa-Kohn-Rostoker (KKR) electronic structure calculation method were used to investigate sigma-phase Fe_{100-x}Re_{x} alloys (x = 4
3, 45, 47, 49 and 53). Structural data such as site occupancies and lattice constants were derived from the XRD patters, while the average isomer shift and distribution curves of the quadrupole splitting were obtained from the Mossbauer spectra. Fe-site charge-densities and the quadrupole splittings were computed with the KKR method for each lattice site. The calculated quantities combined with the experimentally determined site occupancies were successfully used to decompose the measured Mossbauer spectra into five components corresponding to the five sublattices.
Magnetic properties of a $sigma-$Fe$_{16}$Cr$_{14}$ alloy calculated with the charge and spin self- consistent Korringa-Kohn-Rostoker (KKR) and combined with coherent potential approximation (KKR-CPA) methods are reported. Non-magnetic state as well
as various magnetic orderings were considered, i.e. ferromagnetic (FM) and more complex anti-parallel (called APM) arrangements for selected sublattices, as follows from the symmetry analysis. It has been shown that the Stoner criterion applied to non-magnetic density of states at the Fermi energy, $E_F$ is satisfied for Fe atoms situated on all five lattice sites, while it is not fulfilled for all Cr atoms. In FM and APM states, the values of magnetic moments on Fe atoms occupying various sites are dispersed between 0 and 2.5 $mu_B$, and they are proportional to the number of Fe atoms in the nearest-neighbor shell. Magnetic moments of Cr atoms havin much smaller values were found to be coupled antiparallel to those of Fe atoms. The average value of the magnetic moment per atom was found to be $<mu>=0.55 mu_B$ that is by a factor of 4 larger than the experimental value found for a $sigma-$Fe$_{0.538}$Cr$_{0.462}$ sample. Conversely, admitting an anti- parallel ordering (APM model) on atoms situated on C and D sites, according to the group theory and symmetry analysis results, yielded a substantial reduction of $<mu>$ to 0.20 $mu_B$. Further diminution of $<mu>$ to 0.15 $mu_B$, which is very close to the experimental value of 0.14 $mu_B$, has been achieved with the KKR-CPA calculations by considering a chemical disorder on sites B, C and D.
We investigate flux-grown Sm-deficient Sm$_x$B$_6$ ($x < 1$) by global and local tools, including X-ray diffraction (XRD), electronic transport, and scanning tunneling microscopy (STM) and spectroscopy (STS). All these tools indicate a remarkable per
sistence of the SmB$_6$ local structure in the flux-grown samples even for nominal Sm concentrations as low as $x=0.75$. As a consequence, the overall electronic properties of Sm$_x$B$_6$, and particularly the surface conductance at low temperature, is only affected locally by the Sm-deficiency.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
