اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدShifted loops and coercivity from field imprinted high energy barriers in ferritin and ferrihydrite nanoparticles
92
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We show that the coercive field in ferritin and ferrihydrite depends on the maximum magnetic field in a hysteresis loop and that coercivity and loop shifts depend both on the maximum and cooling fields. In the case of ferritin we show that the time dependence of the magnetization also depends on the maximum and previous cooling fields. This behavior is associated to changes in the intra-particle energy barriers imprinted by these fields. Accordingly, the dependence of the coercive and loop shift fields with the maximum field in ferritin and ferrihydrite can be described within the frame of a uniform-rotation model considering a dependence of the energy barrier with the maximum and the cooling fields.
قيم البحث
اقرأ أيضاً
Nanoparticles with their specific properties newly have drawn a great deal of attention of researchers [1-3]Yttrium iron Garnet magnetic nanoparticles (YIG-NPs) are promising materials with novel applications in microwave, spintronics, magnonics, and
magneto-optical devices. However, achieving stable and remarkable magnetic YIG-NPs has been remaining as a great challenge. In this paper, synthesized YIG-NPs by modifying co-precipitation (MCP) method is reported. Structural and magnetic properties of final products are compared to those of the materials prepared by citrate-nitrate (CN) method. Smaller crystals and particle size have been found by MCP method comparing to that of synthesized by CN method. Using a relatively low annealing temperatures for both sets of samples (~700 {deg}C), the final YIG samples prepared by MCP method show more structural purity than those made by CN method. Higher saturation magnetization (Ms) and lower coercivity (Hc) are observed in MCP YIG sample (23.23 emu/g 36 and 30.1 Oe) than the CN prepared YIG sample (16.43 emu/g and 44.95 Oe). The Curie temperature is measured to be 569 {deg}C for the MCP YIG sample determined from set of Ms measurement at different temperatures ranging from 80-600 K. These findings lead to significant improvement in quality of synthesized (synthetic methods) of YIG-NPs.
We report on theoretical investigation of the magnetization reversal in two-dimensional arrays of ferromagnetic nano-particles with parameters of cobalt. The system was optimized for achieving the lowest coercivity in an array of particles located in
the nodes of triangular, hexagonal and square grids. Based on the numerical solution of the non-stochastic Landau-Lifshitz-Gilbert equation we show that each particle distribution type is characterized with a proper optimal distance, allowing to lower the coercivity values for approximately 30% compared with the reference value obtained for a single nano-particle. It was shown that the reduction of coercivity occurs even if the particle position in the array is not very precise. In particular, the triangular particle arrangement maintained the same optimal distance between the particles under up to 20% random displacements of their position within the array.
Cobalt carbide nanoparticles were processed using polyol reduction chemistry that offers high product yields in a cost effective single-step process. Particles are shown to be acicular in morphology and typically assembled as clusters with room tempe
rature coercivities greater than 4 kOe and maximum energy products greater than 20 KJ/m3. Consisting of Co3C and Co2C phases, the ratio of phase volume, particle size, and particle morphology all play important roles in determining permanent magnet properties. Further, the acicular particle shape provides an enhancement to the coercivity via dipolar anisotropy energy as well as offering potential for particle alignment in nanocomposite cores. While Curie temperatures are near 510K at temperatures approaching 700 K the carbide powders experience an irreversible dissociation to metallic cobalt and carbon thus limiting operational temperatures to near room temperature.
We show that the magnetic anisotropy energy of antiferromagnetic ferrihydrite depends on the square root of the nanoparticles volume, using a method based on the analysis of statistical distributions. The size distribution was obtained by transmissio
n electron microscopy, and the anisotropy energy distributions were obtained from ac magnetic susceptibility and magnetic relaxation. The square root dependence corresponds to random local anisotropy, whose average is given by its variance, and can be understood in terms of the recently proposed single phase homogeneous structure of ferrihydrite.
We present Monte Carlo simulations of hysteresis loops of a model of a magnetic nanoparticle with a ferromagnetic core and an antiferromegnetic shell with varying values of the core/shell interface exchange coupling which aim to clarify the microscop
ic origin of exchange bias observed experimentally. We have found loops shifts in the field direction as well as displacements along the magnetization axis that increase in magnitude when increasing the interfacial exchange coupling. Ovelap functions computed from the spin configurations along the loops have been computed to explain the origin and magnitude of these features microscopically.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
