ترغب بنشر مسار تعليمي؟ اضغط هنا

Alcoholic beverages induce superconductivity in FeTe$_{1-x}$S$_x$

195   0   0.0 ( 0 )
 نشر من قبل Keita Deguchi
 تاريخ النشر 2010
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

We found that hot alcoholic beverages were effective in inducing superconductivity in FeTe$_{0.8}$S0$_{.2}$. Heating FeTe$_{0.8}$S0$_{.2}$ compound in various alcoholic beverages enhances the superconducting properties compared to pure water-ethanol mixture as a control. Heating with red wine for 24 hours leads to the largest shielding volume fraction of 62.4% and the highest zero resistivity temperature of 7.8 K. Some components present in alcoholic beverages, other than water and ethanol, have the ability to induce superconductivity in FeTe$_{0.8}$S0$_{.2}$ compound.



قيم البحث

اقرأ أيضاً

159 - K. Deguchi , D. Sato , M. Sugimoto 2012
To elucidate the mechanism as to why alcoholic beverages can induce superconductivity in Fe_{1+d}Te_{1-x}S_x samples, we performed component analysis and found that weak acid such as organic acid has the ability to induce superconductivity. Inductive ly-coupled plasma spectroscopy was performed on weak acid solutions post annealing. We found that the mechanism of inducement of superconductivity in Fe_{1+d}Te_{1-x}S_x is the deintercalation of excess Fe from the interlayer sites.
We have successfully synthesized a new superconducting phase of FeTe1-xSx with a PbO-type structure. It has the simplest crystal structure in iron-based superconductors. Superconducting transition temperature is about 10 K at x = 0.2. The upper criti cal field Hc2 was estimated to be ~70 T. The coherent length was calculated to be ~2.2 nm. Because FeTe1-xSx is composed of nontoxic elements, this material is a candidate for applications and will activate more and more research on iron-based superconductor.
We have fabricated thin films of FeTe$_{1-x}$Se$_x$ using a scotch-tape method. The superconductivities of the thin films are different from each other although these films were fabricated from the same bulk sample. The result clearly presents the in homogeneous superconductivity in FeTe$_{1-x}$Se$_x$. The difference comes from inhomogeneity due to the excess Fe concentration. The resistivity of a thin film with low excess Fe shows good superconductivity with the sharp superconducting-transition width and more isotropic superconductivity.
242 - Y. Mizukami , M. Haze , O. Tanaka 2021
The BCS-BEC crossover from strongly overlapping Cooper pairs to non-overlapping composite bosons in the strong coupling limit has been a long-standing issue of interacting many-body fermion systems. Recently, FeSe semimetal with hole and electron ban ds emerged as a high-$T_{rm c}$ superconductor located in the BCS-BEC crossover regime, owing to its very small Fermi energies. In FeSe, however, an ordinary BCS-like heat-capacity jump is observed at $T_{rm c}$, posing a fundamental question on the characteristics of the BCS-BEC crossover. Here we report on high-resolution heat capacity, magnetic torque, and scanning tunneling spectroscopy measurements in FeSe$_{1-x}$S$_x$. Upon entering the tetragonal phase at $x>0.17$, where nematic order is suppressed, $T_{rm c}$ discontinuously decreases. In this phase, highly non-mean-field behaviors consistent with BEC-like pairing are found in the thermodynamic quantities with giant superconducting fluctuations extending far above $T_{rm c}$, implying the change of pairing nature. Moreover, the pseudogap formation, which is expected in BCS-BEC crossover of single-band superconductors, is not observed in the tunneling spectra. These results illuminate highly unusual features of the superconducting states in the crossover regime with multiband electronic structure and competing electronic instabilities.
The iron-based superconductor FeTe$_{1-x}$Se$_{x}$ has attracted considerable attention as a candidate topological superconductor owing to a unique combination of topological surface states and bulk high-temperature superconductivity. The superconduc ting properties of as-grown single crystals, however, are highly variable and synthesis dependent due to excess interstitial iron impurities incorporated during growth. Here we report a novel physicochemical process for pumping this interstitial iron out of the FeTe$_{1-x}$Se$_{x}$ matrix and achieving bulk superconductivity. Our method should have significant value for the synthesis of high-quality single crystals of FeTe$_{1-x}$Se$_{x}$ with large superconducting volume fractions.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا