اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدDopant-enhanced solid phase epitaxy in buried amorphous silicon layers
121
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The kinetics of intrinsic and dopant-enhanced solid phase epitaxy (SPE) are stud- ied in buried amorphous Si (a-Si) layers in which SPE is not retarded by H. As, P, B and Al profiles were formed by multiple energy ion implantation over a con- centration range of 1 - 30 x 1019 /cm3. Anneals were performed in air over the temperature range 460-660 oC and the rate of interface motion was monitored us- ing time resolved reflectivity. The dopant-enhanced SPE rates were modeled with the generalized Fermi level shifting model using degenerate semiconductor statis- tics. The effect of band bending between the crystalline and amorphous sides of the interface is also considered.
قيم البحث
اقرأ أيضاً
The kinetics of intrinsic and dopant-enhanced solid phase epitaxy (SPE) is stud- ied in amorphous germanium (a-Ge) layers formed by ion implantation on <100> Ge substrates. The SPE rates were measured with a time-resolved reflectivity (TRR) system be
tween 300 and 540 degC and found to have an activation energy of (2.15 +/- 0.04) eV. To interpret the TRR measurements the refractive indices of the a-Ge layers were measured at the two wavelengths used, 1.152 and 1.532 {mu}m. For the first time, SPE rate measurements on thick a-Ge layers (>3 {mu}m) have also been performed to distinguish between bulk and near-surface SPE growth rate behavior. Possible effects of explosive crystallization on thick a-Ge layers are considered. When H is present in a-Ge it is found to have a considerably greater retarding affect on the SPE rate than for similar concentrations in a-Si layers. Hydrogen is found to reduce the pre-exponential SPE velocity factor but not the activation energy of SPE. However, the extent of H indiffusion into a-Ge surface layers during SPE is about one order of magnitude less that that observed for a-Si layers. This is thought to be due to the lack of a stable surface oxide on a-Ge. Dopant enhanced kinetics were measured in a-Ge layers containing uniform concentration profiles of implanted As or Al spanning the concentration regime 1-10 x1019 /cm-3. Dopant compensation effects are also observed in a-Ge layers containing equal concentrations of As and Al, where the SPE rate is similar to the intrinsic rate. Various SPE models are considered in light of these data.
Formation of MnAs quantum dots in a regular ring-like distribution has been found on MBE-grown (GaMn)As surfaces after low-temperature annealing under As capping. The Mn was supplied by out-diffusing Mn interstitials from (GaMn)As. With 5 at% substit
utional Mn the quantum dots appeared for (GaMn)As layers thicker than 500 A. For thinner layers the Mn-rich surfaces, presumably monolayer thick MnAs, are smooth and well-ordered (1x2), and are well suited for continued epitaxial growth.
Chalcogen-hyperdoped silicon shows potential applications in silicon-based infrared photodetectors and intermediate band solar cells. Due to the low solid solubility limits of chalcogen elements in silicon, these materials were previously realized by
femtosecond or nanosecond laser annealing of implanted silicon or bare silicon in certain background gases. The high energy density deposited on the silicon surface leads to a liquid phase and the fast recrystallization velocity allows trapping of chalcogen into the silicon matrix. However, this method encounters the problem of surface segregation. In this paper, we propose a solid phase processing by flash-lamp annealing in the millisecond range, which is in between the conventional rapid thermal annealing and pulsed laser annealing. Flash lamp annealed selenium-implanted silicon shows a substitutional fraction of around 70% with an implanted concentration up to 2.3%. The resistivity is lower and the carrier mobility is higher than those of nanosecond pulsed laser annealed samples. Our results show that flash-lamp annealing is superior to laser annealing in preventing surface segregation and in allowing scalability.
The modelling of interface migration and the associated diffusion mechanisms at the nanoscale level is a challenging issue. For many technological applications ranging from nanoelectronic devices to solar cells, more knowledge of the mechanisms gover
ning the migration of the silicon amorphous/crystalline interface and dopant diffusion during solid phase epitaxy is needed. In this work, silicon recrystallisation in the framework of solid phase epitaxy and the influence on orientation effects have been investigated at the atomic level using empirical molecular dynamics simulations. The morphology and the migration process of the interface has been observed to be highly dependent on the original inter-facial atomic structure. The [100] interface migration is a quasi-planar ideal process whereas the cases [110] and [111] are much more complex with a more diffuse interface. For [110], the interface migration corresponds to the formation and dissolution of nanofacets whereas for [111] a defective based bilayer reordering is the dominant re-growth process. The study of the interface velocity migration in the ideal case of defect free re-growth reveals no difference between [100] and [110] and a decrease by a mean factor of 1.43 for the case [111]. Finally, the influence of boron atoms in the amorphous part on the interface migration velocity is also investigated in the case of [100] orientation.
The direct growth of semiconductors over metals by molecular beam epitaxy is a difficult task due to the large differences in crystallization energy between these types of materials. This aspect is problematic in the context of spintronics, where coh
erent spin-injection must proceed via ballistic transport through sharp interfacial Schottky barriers. We report the realization of single-crystalline ferromagnet/semiconductor/ferromagnet hybrid trilayers using solid-phase epitaxy, with combinations of Fe3Si, Co2FeSi, and Ge. The slow annealing of amorphous Ge over Fe3Si results in a crystalline filmlm identified as FeGe2. When the annealing is performed over Co2FeSi, reflected high-energy electron diffraction and X-ray diffraction indicate the creation of a different crystalline Ge(Co,Fe,Si) compound, which also preserves growth orientation. It was possible to observe independent magnetization switching of the ferromagnetic layers in a Fe3Si/FeGe2/Co2FeSi sample, thanks to the different coercive fields of the two metals and to the quality of the interfaces. This result is a step towards the implementation of vertical spin-selective transistor-like devices.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
