اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدModelling Multi Quantum Well Solar Cell Efficiency
104
0
0.0
(
0
)
تأليف
James P. Connolly
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The spectral response of quantum well solar cells (QWSCs) is well understood. We describe work on QWSC dark current theory which combined with SR theory yields a system efficiency. A methodology published for single quantum well (SQW) systems is extended to MQW systems in the Al(x) Ga(1-x) As and InGa(0.53x) As(x) P systems. The materials considered are dominated by Shockley-Read-Hall (SRH) recombination. The SRH formalism expresses the dark current in terms of carrier recombination through mid-gap traps. The SRH recombination rate depends on the electron and hole densities of states (DOS) in the barriers and wells, which are well known, and of carrier non-radiative lifetimes. These material quality dependent lifetimes are extracted from analysis of suitable bulk control samples. Consistency over a range of AlGaAs controls and QWSCs is examined, and the model is applied to QWSCs in InGaAsP on InP substrates. We find that the dark currents of MQW systems require a reduction of the quasi Fermi level separation between carrier populations in the wells relative to barrier material, in line with previous studies. Consequences for QWSCs are considered suggesting a high efficiency potential.
قيم البحث
اقرأ أيضاً
The quantum well solar cell (QWSC) has been proposed as a flexible means to ensuring current matching for tandem cells. This paper explores the further advantage afforded by the indication that QWSCs operate in the radiative limit because radiative c
ontribution to the dark current is seen to dominate in experimental data at biases corresponding to operation under concentration. The dark currents of QWSCs are analysed in terms of a light and dark current model. The model calculates the spectral response (QE) from field bearing regions and charge neutral layers and from the quantum wells by calculating the confined densities of states and absorption coefficient, and solving transport equations analytically. The total dark current is expressed as the sum of depletion layer and charge neutral radiative and non radiative currents consistent with parameter values extracted from QE fits to data. The depletion layer dark current is a sum of Shockley-Read-Hall non radiative, and radiative contributions. The charge neutral region contribution is expressed in terms of the ideal Shockley radiative and non-radiative currents modified to include surface recombination. This analysis shows that the QWSC is inherently subject to the fundamental radiative efficiency limit at high currents where the radiative dark current dominates, whereas good homojunction cells are well described by the ideal Shockley picture where the limit is determined by radiative and non radiative recombination in the charge neutral layers of the cell.
The quantum well solar cell (QWSC) has been proposed as a route to higher efficiency than that attainable by homojunction devices. Previous studies have established that carriers escape the quantum wells with high efficiency in forward bias and contr
ibute to the photocurrent. Progress in resolving the efficiency limits of these cells has been dogged by the lack of a theoretical model reproducing both the enhanced carrier gen- eration and enhanced recombination due to the quantum wells. Here we present a model which calculates the incremental generation and recombination due to the QWs and is verified by modelling the experimental light and dark current-voltage characteristics of a range of III-V quantum well structures. We find that predicted dark currents are significantly greater than experiment if we use lifetimes derived from homostructure devices. Successful simulation of light and dark currents can be obtained only by introducing a parameter which represents a reduction in the quasi-Fermi level separation.
Silicon solar cells dominate the solar cell market with record lab efficiencies reaching almost 26%. However, after 60 years of research, this efficiency saturated close to the theoretical limit for silicon, and radically new approaches are needed to
further improve the efficiency. Here we present parallel-connected tandem solar cells based on down-conversion via singlet fission. This design allows raising the theoretical power conversion efficiency limit to 45% with far superior stability under changing sunlight conditions in comparison to traditional series tandems. We experimentally demonstrate a silicon/pentacene parallel tandem solar cell that exceeds 100% external quantum efficiency at the main absorption peak of pentacene, showing efficient photocurrent addition and proving this design as a realistic prospect for real-world applications.
Both axial and radial junction nanowire solar cells have their challenges and advantages. However, so far, there is no review that explicitly provides a detailed comparative analysis of both axial and radial junction solar cells. This article reviews
some of the recent results on axial and radial junction nanowire solar cells with an attempt to perform a comparative study between the optical and device behavior of these cells. In particular, we start by reviewing different results on how the absorption can be tuned in axial and radial junction solar cells. We also discuss results on some of the critical device concepts that are required to achieve high efficiency in axial and radial junction solar cells. We include a section on new device concepts that can be realized in nanowire structures. Finally, we conclude this review by discussing a few of the standing challenges of nanowire solar cells.
Extraction of charge carriers from a hot carrier solar cell using energy selective contacts, and the impact on limiting power conversion efficiency is analyzed. It is shown that assuming isentropic conversion of carrier heat into voltage implies zero
power output at all operating points. Under conditions of power output, lower voltages than in the isentropic case are obtained due to the irreversible entropy increase associated with carrier flow. This lowers the limiting power conversion efficiency of a hot carrier solar cell.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
