اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدUltrasonic probing of the elastic properties of PMMA bead packings and their rearrangement during pressure sintering
96
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Ultrasound transmission in PMMA spherical bead packings is investigated during the sintering process under stress. Velocity and amplitude measurements of coherent longitudinal waves are performed to monitor the evolution of the elastic properties of the solid frame from noncohesive packing to sintered granular material. Comparison between the experimental velocity data and the prediction by a contact model [Digby, J. Appl. Mech. 48, 803, (1981)] reveals the crucial role of the bonding effect on the mechanical behavior of granular compacts. By using the correlation technique of acoustic speckles, we also observe the important rearrangements in granular packings before the onset of sintering.
قيم البحث
اقرأ أيضاً
The structural properties of Thallium (III) oxide (Tl2O3) have been studied both experimentally and theoretically under compression at room temperature. X-ray powder diffraction measurements up to 37.7 GPa have been complemented with ab initio total-
energy calculations. The equation of state of Tl2O3 has been determined and compared to related compounds. It has been found experimentally that Tl2O3 remains in its initial cubic bixbyite-type structure up to 22.0 GPa. At this pressure, the onset of amorphization is observed, being the sample fully amorphous at 25.2 GPa. The sample retains the amorphous state after pressure release. To understand the pressure-induced amorphization process, we have studied theoretically the possible high-pressure phases of Tl2O3. Although a phase transition is predicted at 5.8 GPa to the orthorhombic Rh2O3-II-type structure and at 24.2 GPa to the orthorhombic a-Gd2S3-type structure, neither of these phases were observed experimentally, probably due to the hindrance of the pressure-driven phase transitions at room temperature. The theoretical study of the elastic behavior of the cubic bixbyite-type structure at high-pressure shows that amorphization above 22 GPa at room temperature might be caused by the mechanical instability of the cubic bixbyite-type structure which is theoretically predicted above 23.5 GPa.
A numerical model able to simulate solid-state constrained sintering is presented. The model couples an existing kinetic Monte Carlo (kMC) model for free sintering with a finite element model (FEM) for calculating stresses on a microstructural level.
The microstructural response to the local stress as well as the FEM calculation of the stress field from the microstructural evolution is discussed. The sintering behavior of a sample constrained by a rigid substrate is simulated. The constrained sintering results in a larger number of pores near the substrate, as well as anisotropic sintering shrinkage, with significantly enhanced strain in the central upper part of the sample surface, and minimal strain at the edges near the substrate. All these features have also previously been observed experimentally.
Electronic, structural, vibrational and elastic properties of PaN have been studied both at ambient and high pressures, using first principles methods with several commonly used parameterizations of the exchange-correlation energy. The generalized gr
adient approximation (GGA) reproduces the ground state properties satisfactorily. Under pressure PaN is found to undergo a structural transition from NaCl to the R-3m structure near 58 GPa. The high pressure behavior of the acoustic phonon branch along the (1,0,0) and (1,1,0) directions, and the C44 elastic constant are anomalous, which signals the structural transition. With GGA exchange-correlation, a topological transition in the charge density occurs near the structural transition which may be regarded as a quantum phase transition, where the order parameter obeys a mean field scaling law. However, the topological transition is absent when other exchange-correlation functionals are invoked (local density approximation (LDA) and hybrid functional). Therefore, this constitutes an example of GGA and LDA leading to qualitatively different predictions, and it is of great interest to examine experimentally whether this topological transition occurs.
One of the main challenges of the sintering of sterling silver is the phenomenon of swelling causing de-densification and a considerable reduction of the sintering kinetics. This swelling phenomenon opposes sintering and it needs to be addressed by a
well-controlled processing atmosphere. In the present study, the pressure-less sintering behavior of sterling silver is investigated in air, argon, and vacuum. A specially modified spark plasma sintering mold is designed to study the pressure-less sintering of sterling silver in a high vacuum environment. The conducted analysis is extended to the new constitutive equations of sintering enabling the prediction of the swelling phenomena and the identification of the internal equivalent pressure that opposes the sintering.
The dynamical, dielectric and elastic properties of GeTe, a ferroelectric material in its low temperature rhombohedral phase, have been investigated using first-principles density functional theory. We report the electronic energy bands, phonon dispe
rsion curves, electronic and low frequency dielectric tensors, infra-red reflectivity, Born effective charges, elastic and piezoelectric tensors and compare them with the existing theoretical and experimental results, as well as with similar quantities available for other ferroelectric materials, when appropriate.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
