اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدNarrowband nanomechanical mass measurement using nonlinear response of a graphene membrane
114
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We propose a scheme to measure the mass of a single particle using the nonlinear response of a 2D nanoresonator with degenerate eigenmodes. Using numerical and analytical calculations, we show that by driving a square graphene nanoresonator into the nonlinear regime, simultaneous determination of the mass and position of an added particle is possible. Moreover, this scheme only requires measurements in a narrow frequency band near the fundamental resonance.
قيم البحث
اقرأ أيضاً
We study the response of a weakly damped vibrational mode of a nanostring resonator to a moderately strong resonant driving force. Because of the geometry of the experiment, the studied flexural vibrations lack inversion symmetry. As we show, this le
ads to a nontrivial dependence of the vibration amplitude on the force parameters. For a comparatively weak force, the response has the familiar Duffing form, but for a somewhat stronger force, it becomes significantly different. Concurrently there emerge vibrations at twice the drive frequency, a signature of the broken symmetry. Their amplitude and phase allow us to establish the cubic nonlinearity of the potential of the mode as the mechanism responsible for both observations. The developed theory goes beyond the standard rotating-wave approximation. It quantitatively describes the experiment and allows us to determine the nonlinearity parameters.
Current wafer-scale fabrication methods for graphene-based electronics and sensors involve the transfer of single-layer graphene by a support polymer. This often leaves some polymer residue on the graphene, which can strongly impact its electronic, t
hermal, and mechanical resonance properties. To assess the cleanliness of graphene fabrication methods, it is thus of considerable interest to quantify the amount of contamination on top of the graphene. Here, we present a methodology for direct measurement of the mass of the graphene sheet using quartz crystal microbalances (QCM). By monitoring the QCM resonance frequency during removal of graphene in an oxygen plasma, the total mass of the graphene and contamination is determined with sub-graphene-monolayer accuracy. Since the etch-rate of the contamination is higher than that of graphene, quantitative measurements of the mass of contaminants below, on top, and between graphene layers are obtained. We find that polymer-based dry transfer methods can increase the mass of a graphene sheet by a factor of 10. The presented mass measurement method is conceptually straightforward to interpret and can be used for standardized testing of graphene transfer procedures in order to improve the quality of graphene devices in future applications.
In the context of a recoil damping analysis, we have designed and produced a membrane resonator equipped with a specific on-chip structure working as a loss shield for a circular membrane. In this device the vibrations of the membrane, with a quality
factor of $10^7$, reach the limit set by the intrinsic dissipation in silicon nitride, for all the modes and regardless of the modal shape, also at low frequency. Guided by our theoretical model of the loss shield, we describe the design rationale of the device, which can be used as effective replacement of commercial membrane resonators in advanced optomechanical setups, also at cryogenic temperatures.
We present an experiment that systematically probes the basins of attraction of two fixed points of a nonlinear nanomechanical resonator and maps them out with high resolution. We observe a separatrix which progressively alters shape for varying driv
e strength and changes the relative areas of the two basins of attraction. The observed separatrix is blurred due to ambient fluctuations, including residual noise in the drive system, which cause uncertainty in the preparation of an initial state close to the separatrix. We find a good agreement between the experimentally mapped and theoretically calculated basins of attraction.
The ability of graphene to support long-lived, electrically tunable plasmons that interact strongly with light, combined with its highly nonlinear optical response, has generated great expectations for application of the atomically-thin material to n
anophotonic devices. These expectations are mainly reinforced by classical analyses performed using the response derived from extended graphene, neglecting finite-size and nonlocal effects that become important when the carbon layer is structured on the nanometer scale in actual device designs. Here we show that finite-size effects produce large contributions that increase the nonlinear response of nanostructured graphene to significantly higher levels than those predicted by classical theories. We base our analysis on a quantum-mechanical description of graphene using tight-binding electronic states combined with the random-phase approximation. While classical and quantum descriptions agree well for the linear response when either the plasmon energy is below the Fermi energy or the size of the structure exceeds a few tens of nanometers, this is not always the case for the nonlinear response, and in particular, third-order Kerr-type nonlinearities are generally underestimated by the classical theory. Our results reveal the complex quantum nature of the optical response in nanostructured graphene, while further supporting the exceptional potential of this material for nonlinear nanophotonic devices.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
