اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدBinary Star Detection and Parameter Estimation in the RAVE Survey
134
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Although primarily aimed at the galactic archeology and evolution, automated all-sky spectroscopic surveys (RAVE, SDSS) are also a valuable source for the binary star research community. Identification of double-lined spectra is easy and it is not limited by the rare occurrences of eclipses. When the spectrum is properly classified, its atmospheric parameters can be calculated by comparing the spectrum with the best fit atmosphere model. We present the analysis of the binary stars from the sample of roughly 250.000 RAVE survey spectra. The classification and binary discovery method is based on the correlation function analysis. The comparison of these spectra with the model shows that it is possible to estimate the essential atmospheric parameters relatively well. Large number of such estimates and the fact that RAVE consists of a magnitude selected sample without any color cuts makes it suitable for a binary star population study.
قيم البحث
اقرأ أيضاً
Repeated spectroscopic observations of stars in the Radial Velocity Experiment (RAVE) database are used to identify and examine single-lined binary (SB1) candidates. The RAVE latest internal database (VDR3) includes radial velocities, atmospheric and
other parameters for approximately quarter million of different stars with little less than 300,000 observations. In the sample of ~20,000 stars observed more than once, 1333 stars with variable radial velocities were identified. Most of them are believed to be SB1 candidates. The fraction of SB1 candidates among stars with several observations is between 10% and 15% which is the lower limit for binarity among RAVE stars. Due to the distribution of time spans between the re-observation that is biased towards relatively short timescales (days to weeks), the periods of the identified SB1 candidates are most likely in the same range. Because of the RAVEs narrow magnitude range most of the dwarf candidates belong to the thin Galactic disk while the giants are part of the thick disk with distances extending to up to a few kpc. The comparison of the list of SB1 candidates to the VSX catalog of variable stars yielded several pulsating variables among the giant population with the radial velocity variations of up to few tens of km/s. There are 26 matches between the catalog of spectroscopic binary orbits (SB9) and the whole RAVE sample for which the given periastron time and the time of RAVE observation were close enough to yield a reliable comparison. RAVE measurements of radial velocities of known spectroscopic binaries are consistent with their published radial velocity curves.
We report the discovery of RAVE J203843.2-002333, a bright (V = 12.73), very metal-poor ([Fe/H] = -2.91), r-process-enhanced ([Eu/Fe] = +1.64 and [Ba/Eu] = -0.81) star selected from the RAVE survey. This star was identified as a metal-poor candidate
based on its medium-resolution (R ~ 1,600) spectrum obtained with the KPNO/Mayall Telescope, and followed-up with high-resolution (R ~ 66,000) spectroscopy with the Magellan/Clay Telescope, allowing for the determination of elemental abundances for 24 neutron-capture elements, including thorium and uranium. RAVE J2038-0023 is only the fourth metal-poor star with a clearly measured U abundance. The derived chemical-abundance pattern exhibits good agreement with those of other known highly r-process-enhanced stars, and evidence in hand suggests that it is not an actinide-boost star. Age estimates were calculated using Th/X and U/X abundance ratios, yielding a mean age of 13.0 +/- 1.1 Gyr.
We present a novel analysis of the metal-poor star sample in the complete Radial Velocity Experiment (RAVE) Data Release 5 catalog with the goal of identifying and characterizing all very metal-poor stars observed by the survey. Using a three-stage m
ethod, we first identified the candidate stars using only their spectra as input information. We employed an algorithm called t-SNE to construct a low-dimensional projection of the spectrum space and isolate the region containing metal-poor stars. Following this step, we measured the equivalent widths of the near-infrared CaII triplet lines with a method based on flexible Gaussian processes to model the correlated noise present in the spectra. In the last step, we constructed a calibration relation that converts the measured equivalent widths and the color information coming from the 2MASS and WISE surveys into metallicity and temperature estimates. We identified 877 stars with at least a 50% probability of being very metal-poor $(rm [Fe/H] < -2,rm dex)$, out of which 43 are likely extremely metal-poor $(rm [Fe/H] < -3,rm dex )$. The comparison of the derived values to a small subsample of stars with literature metallicity values shows that our method works reliably and correctly estimates the uncertainties, which typically have values $sigma_{rm [Fe/H]} approx 0.2,mathrm{dex}$. In addition, when compared to the metallicity results derived using the RAVE DR5 pipeline, it is evident that we achieve better accuracy than the pipeline and therefore more reliably evaluate the very metal-poor subsample. Based on the repeated observations of the same stars, our method gives very consistent results. The method used in this work can also easily be extended to other large-scale data sets, including to the data from the Gaia mission and the upcoming 4MOST survey.
The Radial Velocity Experiment (RAVE) is a magnitude-limited (9<I<12) spectroscopic survey of Galactic stars randomly selected in the southern hemisphere. The RAVE medium-resolution spectra (R~7500) cover the Ca-triplet region (8410-8795A). The 6th a
nd final data release (DR6 or FDR) is based on 518387 observations of 451783 unique stars. RAVE observations were taken between 12 April 2003 and 4 April 2013. Here we present the genesis, setup and data reduction of RAVE as well as wavelength-calibrated and flux-normalized spectra and error spectra for all observations in RAVE DR6. Furthermore, we present derived spectral classification and radial velocities for the RAVE targets, complemented by cross matches with Gaia DR2 and other relevant catalogs. A comparison between internal error estimates, variances derived from stars with more than one observing epoch and a comparison with radial velocities of Gaia DR2 reveals consistently that 68% of the objects have a velocity accuracy better than 1.4 km/s, while 95% of the objects have radial velocities better than 4.0 km/s. Stellar atmospheric parameters, abundances and distances are presented in subsequent publication. The data can be accessed via the RAVE Web (http://rave-survey.org) or the Vizier database.
The new data release (DR5) of the RAdial Velocity Experiment (RAVE) includes radial velocities of 520,781 spectra of 457,588 individual stars, of which 215,590 individual stars are released in the Tycho-Gaia astrometric solution (TGAS) in Gaia DR1. T
herefore, RAVE contains the largest TGAS overlap of the recent and ongoing Milky Way spectroscopic surveys. Most of the RAVE stars also contain stellar parameters (effective temperature, surface gravity, overall metallicity), as well as individual abundances for Mg, Al, Si, Ca, Ti, Fe, and Ni. Combining RAVE with TGAS brings the uncertainties in space velocities down by a factor of 2 for stars in the RAVE volume -- 10 km/s uncertainties in space velocities are now able to be derived for the majority (70%) of the RAVE-TGAS sample, providing a powerful platform for chemo-dynamic analyses of the Milky Way. Here we discuss the RAVE-TGAS impact on Galactic archaeology as well as how the Gaia parallaxes can be used to break degeneracies within the RAVE spectral regime for an even better return in the derivation of stellar parameters and abundances.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
