اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدThickness-induced insufficient oxygen reduction in La(2-x)CexCuO4 thin films
117
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
A series of electron-doped cuprate La(2-x)CexCuO4 thin films with different thicknesses have been fabricated and their annealing time are adjusted carefully to ensure the highest superconducting transition temperature. The transport measurements indicate that, with the increase of the film thickness (<100 nm), the residual resistivity increases and the Hall coefficient shifts in the negative direction. Further more, the X-ray diffraction data reveal that the c-axis lattice constant c0 increases with the decrease of film thickness. These abnormal phenomena can be attributed to the insufficient oxygen reduction in the thin films. Considering the lattice mismatching in the ab-plane between the SrTiO3 substrates and the films, the compressive stress from the substrates may be responsible for the more difficult reduction of the oxygen in the thin films.
قيم البحث
اقرأ أيضاً
A series of c-axis oriented electron-doped high-Tc superconducting La(2-x)CexCuO4 thin films, from heavily underdoped x=0.06 to heavily overdoped x=0.19, have been synthesized by dc magnetron sputtering technique on (100) SrTiO3 substrates. The influ
ence of various fabrication conditions, such as the deposition temperature and the deposition rate, etc., on the quality of the thin films has been scrutinized. We find that the quality of the films is less sensitive to the deposition temperature in the overdoped region than that in the underdoped region. In the phase diagram of Tc(x), the superconducting dome indicates that the optimally doping level is at the point x=0.105 with the transition temperature Tc0 = 26.5 K. Further more, both the disappearance of the upturn in the $rho_{xx}$(T) curve at low temperature under H=10 T and the positive differential Hall coefficient, $R_H=d rho_{xy}/dH$, are observed around x = 0.15, implying a possible rearrangement of Fermi surface at this doping level.
We have synthesized highly oxygen deficient HfO$_{2-x}$ thin films by controlled oxygen engineering using reactive molecular beam epitaxy. Above a threshold value of oxygen vacancies, p-type conductivity sets in with up to 6 times 10^{21} charge carr
iers per cm3. At the same time, the band-gap is reduced continuously by more than 1 eV. We suggest an oxygen vacancy induced p-type defect band as origin of the observed behavior.
The superconducting properties of high-tc materials are functions of carriers concentration, which is controlled by the concentration of defects including heterovalent cations, interstitial oxygen ions, and oxygen vacancies. Here we combine low-tempe
rature thermal treatment of La$_{2-x}$Sr$_{x}$CuO$_{4}$ epitaxial thin films and confocal Raman spectroscopy to control and investigate oxygen vacancies. We demonstrate that the apical site is the most favorable position to accommodate oxygen vacancies under low-temperature annealing conditions. Additionally we show that in high-quality films of overdoped La$_{2-x}$Sr$_{x}$CuO$_{4}$, oxygen vacancies strongly deform the oxygen environment around the copper ions. This observation is consistent with previous defect-chemical studies, and calls for further investigation of the defect induced properties in the overdoped regime of the hole-doped lanthanum cuprates.
The in-plane penetration depth of Sr$_{0.88}$La$_{0.12}$CuO$_{2+x}$ thin films at various doping obtained from oxygen reduction has been measured, using AC susceptibility measurements. For the higher doping samples, the superfluid density deviates st
rongly from the s-wave behavior, suggesting, in analogy with other electron-doped cuprates, a contribution from a nodal hole pocket, or a small gap on the Fermi surface such as an anisotropic s-wave order parameter. The low value of the superfluid densities, likely due to a strong doping-induced disorder, places the superconducting transition of our samples in the phase-fluctuation regime.
Superconductivity was recently found in the simple tetragonal FeSe structure. Recent studies suggest that FeSe is unconventional, with the symmetry of the superconducting pairing state still under debate. To tackle these problems, clean single crysta
ls and thin films are required. Here we report the fabrication of superconducting beta-phase FeSe1-x thin films on different substrates using a pulsed laser deposition (PLD) technique. Quite interestingly, the crystal orientation, and thus, superconductivity in these thin films is sensitive to the growth temperature. At 320C, films grow preferably along c-axis, but the onset of superconductivity depends on film thickness. At 500C, films grow along (101), with little thickness dependence. These results suggest that the low temperature structural deformation previously found is crucial to the superconductivity of this material.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
