اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدObtaining pressure versus concentration phase diagrams in spin systems from Monte Carlo simulations
76
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We propose an efficient procedure for determining phase diagrams of systems that are described by spin models. It consists of combining cluster algorithms with the method proposed by Sauerwein and de Oliveira where the grand canonical potential is obtained directly from the Monte Carlo simulation, without the necessity of performing numerical integrations. The cluster algorithm presented in this paper eliminates metastability in first order phase transitions allowing us to locate precisely the first-order transitions lines. We also produce a different technique for calculating the thermodynamic limit of quantities such as the magnetization whose infinite volume limit is not straightforward in first order phase transitions. As an application, we study the Andelman model for Langmuir monolayers made of chiral molecules that is equivalent to the Blume-Emery-Griffiths spin-1 model. We have obtained the phase diagrams in the case where the intermolecular forces favor interactions between enantiomers of the same type (homochiral interactions). In particular, we have determined diagrams in the surface pressure versus concentration plane which are more relevant from the experimental point of view and less usual in numerical studies.
قيم البحث
اقرأ أيضاً
Recently, Velazquez and Curilef have proposed a methodology to extend Monte Carlo algorithms based on canonical ensemble, which is aimed to overcome slow sampling problems associated with temperature-driven discontinuous phase transitions. We show in
this work that Monte Carlo algorithms extended with this methodology also exhibit a remarkable efficiency near a critical point. Our study is performed for the particular case of 2D four-state Potts model on the square lattice with periodic boundary conditions. This analysis reveals that the extended version of Metropolis importance sample is more efficient than the usual Swendsen-Wang and Wolff cluster algorithms. These results demonstrate the effectiveness of this methodology to improve the efficiency of MC simulations of systems that undergo any type of temperature-driven phase transition.
The unconstrained ensemble describes completely open systems whose control parameters are chemical potential, pressure, and temperature. For macroscopic systems with short-range interactions, thermodynamics prevents the simultaneous use of these inte
nsive variables as control parameters, because they are not independent and cannot account for the system size. When the range of the interactions is comparable with the size of the system, however, these variables are not truly intensive and may become independent, so equilibrium states defined by the values of these parameters may exist. Here, we derive a Monte Carlo algorithm for the unconstrained ensemble and show that simulations can be performed using chemical potential, pressure, and temperature as control parameters. We illustrate the algorithm by applying it to physical systems where either the system has long-range interactions or is confined by external conditions. The method opens up a new avenue for the simulation of completely open systems exchanging heat, work, and matter with the environment.
We propose a new generalized-ensemble algorithm, which we refer to as the multibaric-multithermal Monte Carlo method. The multibaric-multithermal Monte Carlo simulations perform random walks widely both in volume space and in potential energy space.
From only one simulation run, one can calculate isobaric-isothermal-ensemble averages at any pressure and any temperature. We test the effectiveness of this algorithm by applying it to the Lennard-Jones 12-6 potential system with 500 particles. It is found that a single simulation of the new method indeed gives accurate average quantities in isobaric-isothermal ensemble for a wide range of pressure and temperature.
Population annealing is a recent addition to the arsenal of the practitioner in computer simulations in statistical physics and beyond that is found to deal well with systems with complex free-energy landscapes. Above all else, it promises to deliver
unrivaled parallel scaling qualities, being suitable for parallel machines of the biggest calibre. Here we study population annealing using as the main example the two-dimensional Ising model which allows for particularly clean comparisons due to the available exact results and the wealth of published simulational studies employing other approaches. We analyze in depth the accuracy and precision of the method, highlighting its relation to older techniques such as simulated annealing and thermodynamic integration. We introduce intrinsic approaches for the analysis of statistical and systematic errors, and provide a detailed picture of the dependence of such errors on the simulation parameters. The results are benchmarked against canonical and parallel tempering simulations.
We describe a Monte Carlo procedure which allows sampling of the disjoint configuration spaces associated with crystalline and fluid phases, within a single simulation. The method utilises biased sampling techniques to enhance the probabilities of ga
teway states (in each phase) which are such that a global switch (to the other phase) can be implemented. Equilibrium freezing-point parameters can be determined directly; statistical uncertainties prescribed transparently; and finite-size effects quantified systematically. The method is potentially quite general; we apply it to the freezing of hard spheres.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
