اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدOperation of a Stark decelerator with optimum acceptance
149
0
0.0
(
0
)
نشر من قبل
Sebastiaan Y.T. van de Meerakker
تاريخ النشر
2008
مجال البحث
فيزياء
والبحث باللغة
English
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
With a Stark decelerator, beams of neutral polar molecules can be accelerated, guided at a constant velocity, or decelerated. The effectiveness of this process is determined by the 6D volume in phase space from which molecules are accepted by the Stark decelerator. Couplings between the longitudinal and transverse motion of the molecules in the decelerator can reduce this acceptance. These couplings are nearly absent when the decelerator operates such that only every third electric field stage is used for deceleration, while extra transverse focusing is provided by the intermediate stages. For many applications, the acceptance of a Stark decelerator in this so-called $s=3$ mode significantly exceeds that of a decelerator in the conventionally used ($s=1$) mode. This has been experimentally verified by passing a beam of OH radicals through a 2.6 meter long Stark decelerator. The experiments are in quantitative agreement with the results of trajectory calculations, and can qualitatively be explained with a simple model for the 6D acceptance. These results imply that the 6D acceptance of a Stark decelerator in the $s=3$ mode of operation approaches the optimum value, i.e. the value that is obtained when any couplings are neglected.
قيم البحث
اقرأ أيضاً
We present a combined experimental and theoretical study on the rotationally inelastic scattering of OH ($X,^2Pi_{3/2}, J=3/2, f$) radicals with the collision partners He, Ne, Ar, Kr, Xe, and D$_2$ as a function of the collision energy between $sim 7
0$ cm$^{-1}$ and 400~cm$^{-1}$. The OH radicals are state selected and velocity tuned prior to the collision using a Stark decelerator, and field-free parity-resolved state-to-state inelastic relative scattering cross sections are measured in a crossed molecular beam configuration. For all OH-rare gas atom systems excellent agreement is obtained with the cross sections predicted by close-coupling scattering calculations based on accurate emph{ab initio} potential energy surfaces. This series of experiments complements recent studies on the scattering of OH radicals with Xe [Gilijamse emph{et al.}, Science {bf 313}, 1617 (2006)], Ar [Scharfenberg emph{et al.}, Phys. Chem. Chem. Phys. {bf 12}, 10660 (2010)], He, and D$_2$ [Kirste emph{et al.}, Phys. Rev. A {bf 82}, 042717 (2010)]. A comparison of the relative scattering cross sections for this set of collision partners reveals interesting trends in the scattering behavior.
A microstructured array of 1254 electrodes on a substrate has been configured to generate an array of local minima of electric field strength with a periodicity of 120 $mu$m about 25 $mu$m above the substrate. By applying sinusoidally varying potenti
als to the electrodes, these minima can be made to move smoothly along the array. Polar molecules in low-field seeking quantum states can be trapped in these traveling potential wells. Recently, we experimentally demonstrated this by transporting metastable CO molecules at constant velocities above the substrate [Phys. Rev. Lett. 100 (2008) 153003]. Here, we outline and experimentally demonstrate how this microstructured array can be used to decelerate polar molecules directly from a molecular beam. For this, the sinusoidally varying potentials need to be switched on when the molecules arrive above the chip, their frequency needs to be chirped down in time, and they need to be switched off before the molecules leave the chip again. Deceleration of metastable CO molecules from an initial velocity of 360 m/s to a final velocity as low as 240 m/s is demonstrated in the 15-35 mK deep potential wells above the 5 cm long array of electrodes. This corresponds to a deceleration of almost $10^5$ $g$, and about 85 cm$^{-1}$ of kinetic energy is removed from the metastable CO molecules in this process.
We revisit the operation of the Stark decelerator and present a new, optimized operation scheme, which substantially improves the efficiency of the decelerator at both low and high final velocities, relevant for trapping experiments and collision exp
eriments, respectively. Both experimental and simulation results show that this new mode of operation outperforms the schemes which have hitherto been in use. This new mode of operation could potentially be extended to other deceleration techniques.
We have designed and implemented a new Stark decelerator based on wire electrodes, which is suitable for ultrahigh vacuum applications. The 100 deceleration stages are fashioned out of 0.6 mm diameter tantalum and the arrays total length is 110 mm, a
pproximately 10 times smaller than a conventional Stark decelerator with the same number of electrode pairs. Using the wire decelerator, we have removed more than 90% of the kinetic energy from metastable CO molecules in a beam.
We present a new formalism to calculate phase-space acceptance in a Zeeman decelerator. Using parameters closely mimicking previous Zeeman deceleration experiments, this approach reveals a hitherto unconsidered velocity dependence of the phase stabil
ity which we ascribe to the finite rise and fall times of the current pulses that generate the magnetic fields inside the deceleration coils. It is shown that changing the current switch-off times as the sequence progresses, so as to maintain a constant mean acceleration per pulse, can lead to a constant phase stability and hence a beam with well-defined characteristics. We also find that the time overlap between fields of adjacent coils has an influence on the phase-space acceptance. Previous theoretical and experimental results suggested unfilled regions in phase space that influence particle transmission through the decelerator. Our model provides, for the first time, a means to directly identify the origin of these effects due to coupling between longitudinal and transverse dynamics. Since optimum phase stability is restricted to a rather small parameter range in terms of the reduced position of the synchronous particle, only a limited range of final velocities can be attained using a given number of coils. We evaluate phase stability for different Zeeman deceleration sequences, and, by comparison with numerical three-dimensional particle trajectory simulations, we demonstrate that our model provides a valuable tool to find optimum parameter sets for improved Zeeman deceleration schemes. An acceleration-deceleration scheme is shown to be a useful approach to generating beams with well-defined properties for variable-energy collision experiments. More generally, the model provides significant physical insights applicable to other types of particle decelerators with finite rise and fall time fields.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
