اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدUnusual giant magnetoresistance effect in heterojunction structure of ultra-thin single-crystal Pb film on silicon substrate
181
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Superconductor films on semiconductor substrates draw much attention recently since the derived superconductor-based electronics have been shown promising for future data process and storage technologies. By growing atomically uniform single-crystal epitaxial Pb films of several nanometers thick on Si wafers to form a sharp superconductor-semiconductor heterojunction, we have obtained an unusual giant magnetoresistance effect when the Pb film is superconducting. In addition to the great fundamental interest of this effect, the simple structure and compatibility and scalability with current Si-based semiconductor technology offer a great opportunity for integrating superconducting circuits and detectors in a single chip.
قيم البحث
اقرأ أيضاً
We present ultra-thin silicon membrane thermocouple bolometers suitable for fast and sensitive detection of low levels of thermal power and infrared radiation at room temperature. The devices are based on 40 nm-thick strain tuned single crystalline s
ilicon membranes shaped into heater/absorber area and narrow n- and p-doped beams, which operate as the thermocouple. The electro-thermal characterization of the devices reveal noise equivalent power of 13 pW/rtHz and thermal time constant of 2.5 ms. The high sensitivity of the devices is due to the high Seebeck coefficient of 0.39 mV/K and reduction of thermal conductivity of the Si beams from the bulk value. The bolometers operate in the Johnson-Nyquist noise limit of the thermocouple, and the performance improvement towards the operation close to the temperature fluctuation limit is discussed.
The thermal deposition and transfer Printing method had been used to produce pentacene thin-films on SiO2/Si and plastic substrates (PMMA and PVP), respectively. X-ray diffraction patterns of pentacene thin films showed reflections associated with hi
ghly ordered polycrystalline films and a coexistence of two polymorph phases classified by their d-spacing, d(001): 14.4 and 15.4 A.The dependence of the c-axis correlation length and the phase fraction on the film thickness and printing temperature were measured. A transition from the 15.4 A phase towards 14.4 A phase was also observed with increasing film thickness. An increase in the c-axis correlation length of approximately 12% ~16% was observed for Pn films transfer printed onto a PMMA coated PET substrate at 100~120 C as compared to as-grown Pn films on SiO2/Si substrates. The transfer printing method is shown to be an attractive for the fabrication of pentacene thin-film transistors on flexible substrates partly because of the resulting improvement in the quality of the pentacene film.
We report on fabrication and characterization of ultra-thin suspended single crystalline flat silicon membranes with thickness down to 6 nm. We have developed a method to control the strain in the membranes by adding a strain compensating frame on th
e silicon membrane perimeter to avoid buckling of the released membranes. We show that by changing the properties of the frame the strain of the membrane can be tuned in controlled manner. Consequently, both the mechanical properties and the band structure can be engineered and the resulting membranes provide a unique laboratory to study low-dimensional electronic, photonic and phononic phenomena.
We study the influence of the thickness Df of the plain ferromagnetic (F) film on the electrical resistance of the flux-coupled hybrids, consisting of superconducting (S) Al film and multilayer [Co/Pt] F film with out-of-plain magnetization. The beha
vior of such hybrids at high and low temperatures is found to be different: the nucleation of superconductivity at high temperatures is governed mainly by the typical lateral dimensions of the magnetic domains, while low temperature properties are determined by topology of the magnetic template. We show that an increase in the Df value leads to a broadening of the field- and temperature intervals where non-monotonous dependence of the superconducting critical temperature Tc on the applied magnetic field H is observed (for demagnetized F films). Further increase in the Df value results in a global suppression of superconductivity. Thus, we determined an optimal thickness, when the non-monotonous dependence Tc(H) can be observed in rather broad T and H range, what can be interesting for further studies of the localized superconductivity in planar Al-based S/F hybrids and for development of the devices which can exploit the localized superconductivity.
By computing spin-polarized electronic transport across a finite zigzag graphene ribbon bridging two metallic graphene electrodes, we demonstrate, as a proof of principle, that devices featuring 100% magnetoresistance can be built entirely out of car
bon. In the ground state a short zig-zag ribbon is an antiferromagnetic insulator which, when connecting two metallic electrodes, acts as a tunnel barrier that suppresses the conductance. Application of a magnetic field turns the ribbon ferromagnetic and conducting, increasing dramatically the current between electrodes. We predict large magnetoresistance in this system at liquid nitrogen temperature and 10 Tesla or at liquid helium temperature and 300 Gauss.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
