اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدOn the determination of Poissons ratio of stressed monolayer and bilayer submicron thick films
103
0
0.0
(
0
)
نشر من قبل
EDA Publishing Association
تاريخ النشر
2008
مجال البحث
الهندسة المعلوماتية
والبحث باللغة
English
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
In this paper, the bulge test is used to determine the mechanical properties of very thin dielectric membranes. Commonly, this experimental method permits to determine the residual stress (s0) and biaxial Youngs modulus (E/(1-u)). Associating square and rectangular membranes with different length to width ratios, the Poissons ratio (u) can also be determined. LPCVD Si3N4 monolayer and Si3N4/SiO2 bilayer membranes, with thicknesses down to 100 nm, have been characterized giving results in agreement with literature for Si3N4, E = 212 $pm$ 14 GPa, s0 = 420 $pm$ 8 and u = 0.29.
قيم البحث
اقرأ أيضاً
Negative Poissons ratio (NPR) materials have attracted tremendous interest due to their unusual physical properties and potential applications. Certain two-dimensional (2D) monolayer materials have also been found to exhibit NPR and the corresponding
deformation mechanism varies. In this study, we found, based on first-principles calculations, that the Poissons ratio (PR) sign of monolayer Blue Phosphorus Oxide (BPO) can be tuned by strain: the PR is positive under uniaxial strain <= -1% but becomes negative under > 0. The deformation mechanism for BPO under strain depends on the mutual competition between the P-P attraction and P-O repulsion effect, and these two factors induce two different deformation pathways (one with positive PR, and the other with NPR). Moreover, with increasing of strain, both the decreased strength of P-P attraction and the increased strength of P-O repulsion effect modulate the PR of BPO from positive to negative.
Based on variable components global optimization algorithm, we predict a stable two-dimensional (2D) phase of boron phosphide with 1:5 stoichiometry, i.e. boron pentaphosphide (BP_5) monolayer, which has a lower formation energy than that of the comm
only believed graphitic phase (g-BP). BP_5 monolayer is a multiferroic material with coupled ferroelasticity and ferroelectricity. The predicted reversible strain is up to 41.41%, which is the largest among all reported ferroelastic materials. Due to the non-centrosymmetric structure and electronegativity differences between boron and phosphorus atoms, an in-plane spontaneous polarization of 326.0 pC/m occurs in BP_5. Moreover, the recently hunted negative Poissons ratio property, is also observed in BP_5. As an indirect semiconductor with a band gap of 1.34 eV, BP_5 displays outstanding optical and electronic properties, for instance strongly anisotropic visible-light absorption and high carrier mobility. The rich and extraordinary properties of BP_5 make it a potential nanomaterial for designing electromechanical or optoelectronic devices, such as nonvolatile memory with conveniently readable/writeable capability. Finally, we demonstrate that AlN (010) surface could be a suitable substrate for epitaxy growth of BP_5 monolayer.
Millimeter wave technology being an emerging area is still very undeveloped. A substantial research needs to be done in this area as its applications are numerous. In the present endeavor, a rectangular patch antenna is designed on thick substrate an
d simulated using SONNET software, also a novel analysis technique is developed for circular patch antenna for millimeter wave frequency. The antenna is designed at 39 GHz on thick substrate and has been analyzed and simulated.The results of the theoretical analysis are in good agreement with the simulated results.
We present first-principles calculations of elastic properties of multilayered two-dimensional crystals such as graphene, h-BN and 2H-MoS2 which shows that their Poissons ratios along out-of-plane direction are negative, near zero and positive, respe
ctively, spanning all possibilities for sign of the ratios. While the in-plane Poissons ratios are all positive regardless of their disparate electronic and structural properties, the characteristic interlayer interactions as well as layer stacking structures are shown to determine the sign of their out-of-plane ratios. Thorough investigation of elastic properties as a function of the number of layers for each system is also provided, highlighting their intertwined nature between elastic and electronic properties.
Most materials exhibit positive Poissons ratio (PR) values but special structures can also present negative and, even rarer, zero (or close to zero) PR. Null PR structures have received much attention due to their unusual properties and potential app
lications in different fields, such as aeronautics and bio-engineering. Here, we present a new and simple near-zero PR 2D topological model based on a structural block composed of two smooth and rigid bars connected by a soft membrane or spring. It is not based on re-entrant or honeycomb-like configurations, which have been the basis of many null or quasi-null PR models. Our topological model was 3D printed and the experimentally obtained PR was$-0.003,pm 0.001,$, which is one the closest to zero value ever reported. This topological model can be easily extended to 3D systems and with compression in any direction. The advantages and disadvantages of these models are also addressed.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
