اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدInvestigation of ultrafast laser photonic material interactions: challenges for directly written glass photonics
94
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Currently, direct-write waveguide fabrication is probably the most widely studied application of femtosecond laser micromachining in transparent dielectrics. Devices such as buried waveguides, power splitters, couplers, gratings and optical amplifiers have all been demonstrated. Waveguide properties depend critically on the sample material properties and writing laser characteristics. In this paper we discuss the challenges facing researchers using the femtosecond laser direct-write technique with specific emphasis being placed on the suitability of fused silica and phosphate glass as device hosts for different applications.
قيم البحث
اقرأ أيضاً
A first demonstration and complete characterization of mid-infrared waveguides in diamond are reported in detail. Waveguides were designed for 2.4 um and 8.6 um waveguiding, with their group velocity dispersion was analyzed using femtosecond pulses a
t 2.4 um wavelength propagated through the waveguide and the bulk substrate. The total dispersion was found to be dominated by the bulk material rather than the waveguide, and was on the range of 275 fs2/mm, demonstrating that femtosecond laser written modifications in diamond introduce negligible perturbations to the intrinsic material.
Two-dimensional (2-D) materials are of tremendous interest to integrated photonics given their singular optical characteristics spanning light emission, modulation, saturable absorption, and nonlinear optics. To harness their optical properties, thes
e atomically thin materials are usually attached onto prefabricated devices via a transfer process. In this paper, we present a new route for 2-D material integration with planar photonics. Central to this approach is the use of chalcogenide glass, a multifunctional material which can be directly deposited and patterned on a wide variety of 2-D materials and can simultaneously function as the light guiding medium, a gate dielectric, and a passivation layer for 2-D materials. Besides claiming improved fabrication yield and throughput compared to the traditional transfer process, our technique also enables unconventional multilayer device geometries optimally designed for enhancing light-matter interactions in the 2-D layers. Capitalizing on this facile integration method, we demonstrate a series of high-performance glass-on-graphene devices including ultra-broadband on-chip polarizers, energy-efficient thermo-optic switches, as well as graphene-based mid-infrared (mid-IR) waveguide-integrated photodetectors and modulators.
Laser cooling of a solid is achieved when a coherent laser illuminates the material in the red tail of its absorption spectrum, and the heat is carried out by anti-Stokes fluorescence of the blue-shifted photons. Solid-state laser cooling has been su
ccessfully demonstrated in several materials, including rare-earth-doped crystals and glasses. Silica glass, being the most widely used optical material, has so far evaded all laser cooling attempts. In addition to its fundamental importance, many potential applications can be conceived for anti-Stokes fluorescence cooling of silica. These potential applications range from the substrate cooling of optical circuits for quantum information processing and cryogenic cooling of mirrors in high-sensitivity interferometers for gravitational wave detection to the heating reduction in high-power fiber lasers and amplifiers. Here we report the net cooling of high-purity Yb-doped silica glass samples that are primarily developed for high-power fiber laser applications, where special care has been taken in the fabrication process to reduce their impurities and lower their parasitic background loss. The non-radiative decay rate of the excited state in Yb ions is very small in these glasses due to the low level of impurities, resulting in near-unity quantum efficiency. We report the measurement of the cooling efficiency as a function of the laser wavelength, from which the quantum efficiency of the silica glass is calculated.
Light strongly interacts with structures that are of a similar scale to its wavelength; typically nanoscale features for light in the visible spectrum. However, the optical response of these nanostructures is usually fixed during the fabrication. Pha
se change materials offer a way to tune the properties of these structures in nanoseconds. Until now, phase change active photonics use materials that strongly absorb visible light, which limits their application in the visible spectrum. In contrast, Stibnite (Sb2S3) is an under-explored phase change material with a band gap that can be tuned in the visible spectrum from 2.0 to 1.7 eV. We deliberately couple this tuneable band gap to an optical resonator such that it responds dramatically in the visible spectrum to Sb2S3 reversible structural phase transitions. We show that this optical response can be triggered both optically and electrically. High speed reprogrammable Sb2S3 based photonic devices, such as those reported here, are likely to have wide applications in future intelligent photonic systems, holographic displays, and micro-spectrometers.
Dielectric metasurfaces with spatially varying birefringence and high transmission efficiency can exhibit exceptional abilities for controlling the photonic spin states. We present here some of our works on spin photonics and spin-photonic devices wi
th metasurfaces. We develop a hybrid-order Poincare sphere to describe the evolution of spin states of wave propagation in the metasurface. Both the Berry curvature and the Pancharatnam-Berry phase on the hybrid-order Poincare sphere are demonstrated to be proportional to the variation of total angular momentum. Based on the spin-dependent property of Pancharatnam-Berry phase, we find that the photonic spin Hall effect can be observed when breaking the rotational symmetry of metasurfaces. Moreover, we show that the dielectric metasurfaces can provide great flexibility in the design of novel spin-photonic devices such as spin filter and spin-dependent beam splitter.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
