ترغب بنشر مسار تعليمي؟ اضغط هنا

Group Theoretical Construction of Nucleon Operators using All-to-All Quark Propagators

160   0   0.0 ( 0 )
 نشر من قبل Keisuke Jimmy Juge
 تاريخ النشر 2007
  مجال البحث
والبحث باللغة English




اسأل ChatGPT حول البحث

We describe a method to construct irreducible baryon operators using all-to-all quark propagators. It was demonstrated earlier that a large basis of extended baryon operators on anisotropic, quenched lattices can be used to reliably extract the masses of 5 or more excited states in the nucleon channel. All-to-all quark propagators are expected to be needed when studying these excited states on light, dynamical configurations because contributions from multi-particle states are expected to be significant. The dilution method is used to approximate the all-to-all quark propagators. Low-lying eigenmodes can also be used if necessary. For efficient computation of matrix elements of the interpolating operators, the algorithms should exploit the fact that many extended baryon operators can be obtained from the different linear combinations of three-quark colour-singlet operators. The sparseness of the diluted noise vectors also afford several computation simplifications. Some preliminary results are presented for nucleon effective masses.



قيم البحث

اقرأ أيضاً

291 - J. Bulava , R. Edwards , K.J. Juge 2008
Hadron spectroscopy on dynamical configurations are faced with the difficulties of dealing with the mixing of single particle states and multi-hadron states (for large spatial volumes and light dynamical quarks masses). It is conceivable that explici t multi-hadron interpolating operators will be necessary for obtaining sufficiently good overlap onto multi-hadron states in order to extract the low-lying excitation spectrum. We explore here the feasibility of using four noise diluted all-to-all quark propagators in the construction of explicit two-hadron operators on quenched, anisotropic lattices. Our longer term goal is to use these operators on large anisotropic, dynamical configurations for hadron spectroscopy.
67 - J. Peisa , C. Michael 1997
We measure the ground and excited states for B mesons in the static limit using maximally variance reduced estimators for light quark propagators. Because of the large number of propagators we are able to measure accurately also orbitally excited P, D and F states. We also present some results for Lambda_b.
We present a study of gauge invariant density-density correlators. Density-density correlators probe hadron wave functions and thus can be used to study hadron deformation. Their zero momentum projection requires the computation of all-to-all propaga tors, which are evaluated with the standard stochastic technique, the dilution method and the stochastic sequential technique. We compare the results to a previous analysis that did not employ the zero momentum projection.
In this paper, employing an all-to-all quark propagator technique, we investigate the kaon-nucleon interactions in lattice QCD. We calculate the S-wave kaon-nucleon potentials at the leading order in the derivative expansion in the time-dependent HAL QCD method, using (2+1)-flavor gauge configurations at the lattice spacing $a approx 0.09$ fm on $32^3 times 64$ lattices and the pion mass $m_{pi} approx 570$ MeV. We take the one-end trick for all-to-all propagators, which allows us to put the zero momentum hadron operators at both source and sink and to smear quark operators at the source. We find the stronger repulsive interaction in the $I=1$ channel than in the $I=0$. The phase shifts obtained by solving the Schr{o}dinger equations with the potentials qualitatively reproduce the energy dependence of the experimental phase shifts, and have the similar behavior to the previous results from lattice QCD without all-to-all propagators. Our study demonstrates that the all-to-all quark propagator technique with the one-end trick is useful to study interactions for meson-baryon systems in the HAL QCD method, so that we will apply it to meson-baryon systems which contain quark-antiquark creation/annihilation processes in our future studies.
We report on our calculation of the pion electromagnetic form factor with two-flavors of dynamical overlap quarks. Gauge configurations are generated using the Iwasaki gauge action on a 16^3 times 32 lattice at the lattice spacing of 0.12fm with sea quark masses down to m_s/6, where m_s is the physical strange quark mass. We describe our setup to measure the form factor through all-to-all quark propagators and present preliminary results.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا